Sample &
Buy
Support &
Community
Product
Folder
Tools &
Software
Technical
Documents
TPS75100, TPS75103, TPS75105
SBVS080J –SEPTEMBER 2006–REVISED NOVEMBER 2016
TPS7510x Low Dropout, Two-Bank LED Driver With PWM Brightness Control
1 Features
3 Description
The TPS7510x linear low dropout (LDO) matching
LED current source is optimized for low-power
keypad and navigation pad LED backlighting
applications. The device provides a constant current
to up to four unmatched LEDs organized in two banks
of two LEDs each in a common-cathode topology.
Without an external resistor, the current source
defaults to a factory-programmable, preset current
level with ±0.5% accuracy (typical). An optional
external resistor can be used to set initial brightness
to user-programmable values with higher accuracy.
Brightness can be varied from off to full brightness by
inputting a pulse width modulation (PWM) signal on
each enable pin (ENx, where x indicates LED bank A
or B). Each bank has independent enable and
brightness control, but current matching is done to all
four channels concurrently. The input supply range is
ideally suited for single-cell Li-Ion battery supplies
and the TPS7510x can provide up to 25 mA per LED.
1
•
Regulated Output Current with 2% LED-to-LED
Matching
•
•
Drives Up to Four LEDs at 25 mA Each in a
Common Cathode Topology
28-mV Typical Dropout Voltage Extends Usable
Supply Range in Li-Ion Battery Applications
•
•
Brightness Control Using PWM Signals
Two 2-LED Banks With Independent Enable and
PWM Brightness Control per Bank
•
•
No Internal Switching Signals—Eliminates EMI
Default LED Current Eliminates External
Components
–
Default Values from 3 mA to 10 mA (in 1-mA
Increments) Available Using Innovative Factory
EEPROM Programming
–
Optional External Resistor can be Used for
High-Accuracy, User-Programmable Current
No internal switching signals are used, eliminating
troublesome electromagnetic interference (EMI). The
TPS7510x is offered in an ultra-small, 9-ball, 0.4-mm
ball-pitch wafer chip-scale package (WCSP) and a
2.50-mm × 2.50-mm, 10-pin WSON package, yielding
a very compact total solution size ideal for mobile
handsets and portable backlighting applications. The
device is fully specified over TJ = –40°C to +85°C.
•
•
Over current and Over temperature Protection
Available in Wafer Chip-Scale Package
or 2.50-mm × 2.50-mm WSON-10
2 Applications
•
•
•
•
Keypad and Display Backlighting
White and Color LEDs
Cellular Handsets
Device Information(1)
PART NUMBER
PACKAGE
WSON (10)
DSBGA (9)
BODY SIZE (NOM)
2.50 mm × 2.50 mm
1.208 mm x 1.208 mm
PDAs and Smartphones
TPS7510x
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Typical Application Diagram
VBATT
TPS7510x
VIN
D1A
D2A
VENA
VENB
ENA
ENB
D1B
D2B
ISET
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.