5秒后页面跳转
TDA1566TH/N2S,112 PDF预览

TDA1566TH/N2S,112

更新时间: 2024-09-17 15:54:07
品牌 Logo 应用领域
恩智浦 - NXP 放大器光电二极管商用集成电路
页数 文件大小 规格书
46页 290K
描述
TDA1566 - I2C-bus controlled dual channel 46 W/2 Ohm, single channel 92 W/1 Ohm amplifier with load diagnostic features SOIC 24-Pin

TDA1566TH/N2S,112 技术参数

Source Url Status Check Date:2013-06-14 00:00:00是否Rohs认证: 符合
生命周期:End Of Life零件包装代码:SOIC
包装说明:PLASTIC, SOT-566-3, HSOP-24针数:24
Reach Compliance Code:compliant风险等级:5.7
标称带宽:20 kHz商用集成电路类型:AUDIO AMPLIFIER
增益:26 dB谐波失真:10%
JESD-30 代码:R-PDSO-G24长度:15.9 mm
湿度敏感等级:1信道数量:2
功能数量:1端子数量:24
最高工作温度:85 °C最低工作温度:-40 °C
标称输出功率:150 W封装主体材料:PLASTIC/EPOXY
封装代码:SSOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, SHRINK PITCH峰值回流温度(摄氏度):NOT SPECIFIED
座面最大高度:3.5 mm最大供电电压 (Vsup):18 V
最小供电电压 (Vsup):6.5 V表面贴装:YES
温度等级:INDUSTRIAL端子形式:GULL WING
端子节距:1 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:11 mm
Base Number Matches:1

TDA1566TH/N2S,112 数据手册

 浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第2页浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第3页浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第4页浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第5页浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第6页浏览型号TDA1566TH/N2S,112的Datasheet PDF文件第7页 
TDA1566  
I2C-bus controlled dual channel 46 W/2 , single channel  
92 W/1 amplifier with load diagnostic features  
Rev. 02 — 20 August 2007  
Product data sheet  
1. General description  
The TDA1566 is a car audio power amplifier with a complementary output stage realized  
in BCDMOS. The TDA1566 has two Bridge Tied Load (BTL) output stages and comes in a  
HSOP24 or DBS27P package.  
The TDA1566 can be controlled with or without I2C-bus. With I2C-bus control gain settings  
per channel and diagnostic trigger levels can be selected. Failure conditions as well as  
load identification can be read with I2C-bus. The load identification detects whether the  
outputs of a BTL channel are connected with a DC or AC load and discriminates between  
a speaker load, a line driver load and an open (unconnected) load.  
The TDA1566 can be configured in a single BTL mode and drive a 1 load. For the single  
BTL mode it is necessary to connect on the Printed-Circuit Board (PCB) the outputs of  
both BTL channels in parallel.  
2. Features  
I Operates in I2C-bus mode and non-I2C-bus mode  
I TH version: four I2C-bus addresses controlled by two pins; J version: two I2C-bus  
addresses controlled by one pin  
I Two 4 or 2 capable BTL channels or one 1 capable BTL channel  
I Low offset  
I Pop free off/standby/mute/operating mode transitions  
I Speaker fault detection  
I Selectable gain (26 dB and 16 dB)  
I In I2C-bus mode:  
N DC load detection: open, short and speaker or line driver present  
N AC load (tweeter) detection  
N Programmable trigger levels for DC and AC load detection  
N Per channel programmable gain (26 dB and 16 dB, selectable per channel)  
N Selectable diagnostic levels for clip detection and thermal pre-warning  
N Selectable information on the DIAG pin for clip information of each channel  
separately and independent enabling of thermal-, offset- or load fault  
I Independent short-circuit protection per channel  
I Loss of ground and open VP safe  
I All outputs short-circuit proof to VP, GND and across the load  
I All pins short-circuit proof to ground  
I Temperature controlled gain reduction at high junction temperatures  
 
 

与TDA1566TH/N2S,112相关器件

型号 品牌 获取价格 描述 数据表
TDA1566TH/N2S,118 NXP

获取价格

TDA1566 - I2C-bus controlled dual channel 46 W/2 Ohm, single channel 92 W/1 Ohm amplifier
TDA1572 NXP

获取价格

AM receiver circuit
TDA1572T NXP

获取价格

AM receiver
TDA1572T/V3,112 NXP

获取价格

TDA1572T
TDA1572TD NXP

获取价格

IC AM, AUDIO SINGLE CHIP RECEIVER, PDSO20, Receiver IC
TDA1574 NXP

获取价格

Integrated FM tuner for radio receivers
TDA1574 GSG

获取价格

Integrated FM Tuner for Radio Receivers
TDA1574N NXP

获取价格

暂无描述
TDA1574T NXP

获取价格

Integrated FM tuner for radio receivers
TDA1574TD NXP

获取价格

IC 1-BAND, AUDIO TUNER, PDSO20, Tuner IC