TC74HC423AP/AF
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC74HC423AP,TC74HC423AF
Dual Retriggerable Monostable Multivibrator
The TC74HC423A is a high speed CMOS MONOSTABLE
MULTIVIBRATOR fabricated with silicon gate C2MOS
TC74HC423AP
technology.
It achieves the high speed operation similar to equivalent
LSTTL while maintaining the CMOS low power dissipation.
There are two trigger inputs, A input (negative edge), and B
input (positive edge). These inputs are valid for a slow rise/fall
time signal (tr = tf = 1 s) as they are schmitt trigger inputs.
After triggering, the output stays in a MONOSTABLE state for
a time period determined by the external resistor and capacitor
(Rx, Cx ). A low level at the CLR input breaks this state. In the
MONOSTABLE state, if a new trigger is applied, it extends the
TC74HC423AF
MONOSTABLE period (retrigger mode).
Limitations for Cx and Rx are:
External capacitor, Cx: No limit
External resistor, Rx: V
V
= 2.0 V more than 5 kΩ
≥ 3.0 V more than 1 kΩ
CC
CC
All inputs are equipped with protection circuits against static
discharge or transient excess voltage.
Weight
DIP16-P-300-2.54A
SOP16-P-300-1.27A
Features (Note)
: 1.00 g (typ.)
: 0.18 g (typ.)
•
•
High speed: t = 25 ns (typ.) at V
= 5 V
CC
pd
Low power dissipation
Standby state: I
= 4 μA (max) at Ta = 25°C
CC
Active state: I
= 700 μA (max) at V
= 5 V
(min)
CC
CC
•
•
•
•
•
•
High noise immunity: V
= V = 28% V
NIL CC
NIH
Output drive capability: 10 LSTTL loads
Symmetrical output impedance: |I | = I
= 4 mA (min)
OL
OH
∼
−
Balanced propagation delays: t
t
pHL
pLH
Wide operating voltage range: V
(opr) = 2~6 V
CC
Pin and function compatible with 74LS423
Note: In the case of using only one circuit, CLR should be tied to GND, Rx/Cx・Cx・Q・ Q should be tied to
OPEN, the other inputs should be tied to V
or GND.
CC
1
2007-10-01