4 Mbit Flash + 1 Mbit or 256 Kbit SRAM ComboMemory
SST31LF041 / SST31LF041A / SST31LF043 / SST31LF043A
SST31LF041 / 041A4Mb Flash (x8) + 1 Mb SRAM (x8) ComboMemories
Data Sheet
FEATURES:
•
Monolithic Flash + SRAM ComboMemory
•
•
Fast Read Access Times:
– SST31LF041/043 Flash: 70 ns
SRAM: 70 ns
– SST31LF041A/043A Flash: 300 ns
– SST31LF041/041A: 512K x8 Flash + 128K x8 SRAM
– SST31LF043/043A: 512K x8 Flash + 32K x8 SRAM
•
•
Single 3.0-3.6V Read and Write Operations
Concurrent Operation
SRAM: 300 ns
Flash Fast Erase and Byte-Program:
– Read from or write to SRAM while
– Sector-Erase Time: 18 ms (typical)
– Bank-Erase Time: 70 ms (typical)
– Byte-Program Time: 14 µs (typical)
– Bank Rewrite Time: 8 seconds (typical)
Erase/Program Flash
•
•
Superior Reliability
– Endurance: 100,000 Cycles (typical)
– Greater than 100 years Data Retention
•
•
Flash Automatic Erase and Program Timing
– Internal VPP Generation
Low Power Consumption:
– Active Current: 10 mA (typical) for Flash and
20 mA (typical) for SRAM Read
– Standby Current: 10 µA (typical)
Flash End-of-Write Detection
– Toggle Bit
– Data# Polling
•
•
Flash Sector-Erase Capability
– Uniform 4 KByte sectors
•
•
•
CMOS I/O Compatibility
JEDEC Standard Command Set
Packages Available
Latched Address and Data for Flash
– 32-lead TSOP (8 x 14 mm) SST31LF041A/043A
– 40-lead TSOP (10 x 14 mm) SST31LF041/043
PRODUCT DESCRIPTION
The SST31LF041/041A/043/043A devices are a 512K x8
CMOS flash memory bank combined with a 128K x8 or
32K x8 CMOS SRAM memory bank manufactured with
SST’s proprietary, high performance SuperFlash technol-
ogy. The SST31LF041/041A/043/043A devices write
(SRAM or flash) with a 3.0-3.6V power supply. The mono-
lithic SST31LF041/041A/043/043A devices conform to
Software Data Protect (SDP) commands for x8
EEPROMs.
memory banks share common address lines, data lines,
WE# and OE#. The memory bank selection is done by
memory bank enable signals. The SRAM bank enable sig-
nal, BES# selects the SRAM bank and the flash memory
bank enable signal, BEF# selects the flash memory bank.
The WE# signal has to be used with Software Data Protec-
tion (SDP) command sequence when controlling the Erase
and Program operations in the flash memory bank. The
SDP command sequence protects the data stored in the
flash memory bank from accidental alteration.
Featuring high performance Byte-Program, the flash mem-
ory bank provides a maximum Byte-Program time of 20
µsec. The entire flash memory bank can be erased and
programmed byte-by-byte in typically 8 seconds, when
using interface features such as Toggle Bit or Data# Polling
to indicate the completion of Program operation. To protect
against inadvertent flash write, the SST31LF041/041A/
043/043A devices have on-chip hardware and Software
Data Protection schemes. Designed, manufactured, and
The SST31LF041/041A/043/043A provide the added func-
tionality of being able to simultaneously read from or write
to the SRAM bank while erasing or programming in the
flash memory bank. The SRAM memory bank can be read
or written while the flash memory bank performs Sector-
Erase, Bank-Erase, or Byte-Program concurrently. All flash
memory Erase and Program operations will automatically
latch the input address and data signals and complete the
operation in background without further input stimulus
requirement. Once the internally controlled Erase or Pro-
gram cycle in the flash bank has commenced, the SRAM
bank can be accessed for Read or Write.
tested for
a wide spectrum of applications, the
SST31LF041/041A/043/043A devices are offered with a
guaranteed endurance of 10,000 cycles. Data retention is
rated at greater than 100 years.
The SST31LF041/041A/043/043A operate as two inde-
pendent memory banks with respective bank enable sig-
nals. The SRAM and Flash memory banks are
superimposed in the same memory address space. Both
The SST31LF041/041A/043/043A devices are suited for
applications that use both nonvolatile flash memory and
volatile SRAM memory to store code or data. For all sys-
tem applications, the SST31LF041/041A/043/043A
©2001 Silicon Storage Technology, Inc.
The SST logo and SuperFlash are registered trademarks of Silicon Storage Technology, Inc.
ComboMemory are trademarks of Silicon Storage Technology, Inc.
These specifications are subject to change without notice.
S71107-03-000 5/01
1
349
5秒后页面跳转
STM32H743技术深度剖析与应用案例探索
LM321中文资料解析：引脚功能介绍、技术特点、技术特性分析
74HC14芯片资料介绍：性能特性分析、引脚介绍
LM1875芯片手册：功放参数分析、引脚说明、电路设计要点
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
技术参数
数据手册
如果您发现信息不准确，
