SiC822, SiC822A
www.vishay.com
Vishay Siliconix
70 A VRPower®, Smart Power Stage
With Current Sensing and Temperature Monitor
(Datasheet in Brief)
FEATURES
• Thermally enhanced PowerPAK® MLP56-39L package
• Optimize MOSFET switching performance with integrated
Schottky diode in LS MOSFET
• Up to 70 A continuous current
• High frequency operation up to 2 MHz
• Power MOSFETs optimized for 12 V input stage and
10 % to 15 % duty cycle operation
• 3.3 V and 5 V PWM logic with tri-state and hold-off
• PWM minimum controllable on time of 30 ns
DESCRIPTION
• Diode emulation mode at light loads for high efficiency
over the full load range using GLCTRL pin
The SiC822 is an integrated power stage solution optimized
for synchronous buck applications to offer high current, high
efficiency, and high power density performance. Packaged
in Vishay’s 5 mm x 6 mm MLP package, SiC822 enables
voltage regulator design to deliver in excess of 70 A per
phase current.
• Low PWM propagation delay (< 20 ns)
• Current sense monitor (IMON
)
• Temperature monitor (TMON
• Over temperature alert
)
The
internal
power
MOSFETs
utilize
Vishay’s
state-of-the-art TrenchFET® Gen IV technology that delivers
industry bench mark performance to significantly reduce
switching and conduction losses.
• HS MOSFET over-current and short alert
• Under voltage lockout for VDRV and BOOT
• Material categorization: for definitions of compliance
please see www.vishay.com/doc?99912
The SiC822 incorporates an advanced MOSFET gate driver
IC that features high current driving capability, adaptive
dead-time control, and integrated bootstrap switch, a
thermal monitor that alerts the system of excessive junction
temperature. This driver is also compatible with wide range
of PWM controllers with the support of both 3.3 V and 5 V
PWM logic with tri-state. Diode emulation mode can be
enabled at light loads through the use of GLCTRL signal.
The device also integrates a current monitor to provide a real
time scale down of inductor current (IMON). A temperature
monitor provides the system an indication of the power
stage internal temperature (TMON) and can be used to
throttle the system operation down to a safer level if needed.
The device also integrates fault alerts such as HS FET
over-current, over temperature and HS MOSFET short
failures.
APPLICATIONS
• Synchronous buck converters
• Multi-phase VRDs for CPU, GPU, and memory
• DC/DC VR modules
EFFICIENCY
Axis Title
96
94
92
90
88
86
84
82
80
10000
1000
100
VO = 1.8 V, FSW = 600 kHz
VO = 1.8 V, FSW = 800 kHz
VO = 1.2 V, FSW = 800 kHz
VO = 1.2 V, FSW = 600 kHz
10
0
10
20
30
40
IOUT - Output Current (A)
Fig. 1 - Efficiency vs. Output Current
(VIN = 12 V, L = 100 nH, VCC = VDRV = 5 V)
S21-0583-Rev. C, 14-Jun-2021
Document Number: 74588
1
For technical questions, contact: powerictechsupport@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000