SF1141B 75 MHz SAW Filter
·
·
·
·
Designed for SDARS IF Receiver
Low Insertion Loss
5.0 x 7.0 mm Surface-Mount Case
Differential Input and Output
See Associated Plots
Characteristic
Nominal Center Frequency
Passband
Sym
fc
IL
Min
Typ
75.000
12.5
Max
Units Notes
MHz
dB
1
Insertion Loss at fc
16.0
1 dB Passband BW1
MHz
1, 2
±6.35
±7.43
Fast Amplitude Ripple over fc ±6.35 MHz
Group Delay Variation over fc ±6.35 MHz
1.5
200
dBP-P
nsP-P
GDV
75
Rejection
40
30
45
36
dB
1, 2, 3
1
fc-18.8 to fc-10.95 MHz and fc+18.8 to fc+100MHz
fc+10.95 to fc+18.8 MHz
Operating Temperature Range
TA
-40
+85
°C
Differential Input and Output Impedance
Case Style
Lid Symbolization (YY = year, WW = week)
250 ohms
SMP-03 7 x 5 mm Nominal Footprint
RFM SF1141B YYWW
Absolute Maximum Ratings
Electrical Connections
Rating
Value
+10
30
Units
Connection Terminals
Port 1 Hot 10
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Max Soldering Profile
dBm
VDC
°C
Port 1 Gnd Return
Port 2 Hot
Port 2 Gnd Return
1
5
6
-40 to +85
265°C for 10 s
Case Ground All others
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified
demonstration board with impedance matching to 50 W and measured with 50 W network analyzer. Matching components
maximum 2 inductors (Q=30), 2 capacitors and one resistor or transformer at each input and output.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is
dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching
may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. ã Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc.
4347 Sigma Road
Dallas, Texas 75244
USA
Phone: +1(972)233-2903
Fax: +1(972)387-8148
e-mail: info@rfm.com
European Sales Office
Home page: www.rfm.com
SF1141B.doc 11/6/00 D