SF1183B
•
•
•
•
RF Filter for Mobile Communication Applications
Low Insertion Loss
3.0 x 3.0 x 1.3 mm Surface-Mount Case
No Matching Circuit Required
881.5 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Value
+15
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
-5 to +5
-40 to +100
SM3030-6
Max Soldering Profile
265°C for 10 s
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
Nominal Operating Frequency
f
1
881.5
MHz
C
Passband
Insertion Loss across 869-894
IL
2.8
3.5
1.6
dB
Amplitude Ripple p-p across 869-894
DC ~ 779 MHz
0.7
Attenuation
1, 2, 3
50
45
28
50
40
60.1
49.8
31.1
62.1
47.2
1.6
779 ~ 849 MHz
dB
914 ~970 MHz
970 ~ 1049 MHz
1049 ~ 2000 MHz
VSWR across 869-894
Source impedance
Load impedance
2.0
Z
50
W
W
S
Z
50
L
Operating Temperature
T
1
-30
+85
°C
A
Single Ended Input / Output, Impedance match
Case Style
No matching network required for operation at 50 ohms
SM3030-6 3 x 3 mm Nominal Footprint
RFM SF1183B YYWW
Lid Symbolization (YY=year, WW=week)
50
Electrical Connections
pin 2
pin 5
Connection
Input
Terminals
SAW Filter
TOP VIEW
2
5
50
Output
All Others
Ground
All others
Notes:
5. The design, manufacturing process, and specifications of this filter
are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the
design. However, impedances and impedance matching may vary
between Port 1 and Port 2, so that the filter must always be installed
in one direction per the circuit design.
1. Unless noted otherwise, all specifications apply over the operating
temperature range with filter soldered to the specified demonstration
board with impedance matching to 50 W and measured with 50 W net-
work analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to
the nominal center frequency, fc.
7. US and international patents may apply.
3. Rejection is measured as attenuation below the minimum IL point in
the passband. Rejection in final user application is dependent on
PCB layout and external impedance matching design. See Applica-
tion Note No. 42 for details.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
9. ©Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
4. "LRIP" or "L" after the part number indicates "low rate initial produc-
tion" and "ENG" or "E" indicates "engineering prototypes."
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF1183B-100101
Page 1 of 2
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.