RFM products are now
Murata products.
SF1146B
•
•
•
Low Insertion Loss
5.0 X 7.0 mm Surface-Mount Case
Complies with Directive 2002/95/EC (RoHS)
499.25 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Value
+10
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
30
-40 to +85
Suitable for lead-free soldering - Max Soldering Profile
260°C for 30 s
SMP-03
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
Nominal Center Frequency
fC
IL
499.25
MHz
dB
1
Passband
Rejection
Insertion Loss at fc
3.5
1.5 dB Passband
fc±1.5 MHz
BW1
1, 2
±15
5
kHz
1, 2, 3
dB
°C
fc±6.0 MHz
20
50
-40
fc±50 MHz
Operating Temperature Range
TA
1
6
+85
Differential Input and Output Impedance after matching
Case Style
50 ohms
SMP-03 7 x 5 mm Nominal Footprint
RFM SF1146B YYWWS
Lid Symbolization (YY=year, WW=week, S=shift) See note 4
Electrical Connections
Connection
Terminals
Port 1 Hot
10
Port 1 Ground Return
Port 2 Hot
1
5
6
Port 2 Ground Return
Case Ground
All Others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with
impedance matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Tape and Reel Standard ANSI / EIA 481.
7. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
8. US and international patents may apply.
9. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd.
©2010-2014 by Murata Electronics N.A., Inc.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved 2007
SF1146B (R) 3/19/14
Page 1 of 3
www.murata.com