PF1007-02
SED15A6
SED15A6
Dot Matrix LCD Driver
■ Support up to 55×102 Display
■ Built-in Power Supply Circuit for LCD
■ Few External Parts Required
■ OVERVIEW
The SED15A6 series is a single-chip liquid crystal display (=LCD) driver for dot-matrix LCDs that can be con-
nected directly to a microprocessor (=MPU) bus. It accepts 8-bit parallel or serial display data from a MPU,
stores it in an on-chip display data RAM (=DDRAM), and generates a LCD drive signal independent of the MPU
clock.
The use of the on-chip DDRAM of 65×102 bits and a one-to-one correspondence between LCD panel pixel dots
and on-chip DDRAM bits offer high flexibility in graphic display.
The SED15A6 series does not need external operation clock for DDRAM read/write operations, and has a on-
chip LCD power supply circuit featuring very low current consumption with few external components, and
moreover has a on-chip CR oscillator circuit.
And the SED15A6 does not need smoothing capacitor on the LCD power supply.
Consequently, the SED15A6 series can be realize a high-performance handy display system with a minimum
current consumption and the fewest components.
■ FEATURES
■ Direct display of RAM data through the display data RAM.
■ RAM bit data : “1” Non-illuminated
“0” Illuminated
(during normal display)
■ RAM capacity 65×102 = 6630 bits
■ Display driver circuits
SED15A6*
:
55 common output and 102 segment outputs
**
■ High-speed 8-bit MPU interface (The chip can be connected directly to the 8080 series MPUs and the 6800
series MPUs)
■ High-speed Serial interface are supported.
■ Abundant command functions
Display data Read/Write, display ON/OFF, Normal/Reverse display mode, page address set, display start
line set, column address set, display all points ON/OFF, LCD bias set, electronic volume, read/modify/write,
segment driver direction select, power saver, common driver direction select, V0 voltage regulation internal
resistor ratio set.
■ Low-power liquid crystal display power supply circuit equipped internally.
Booster circuit(with Boost ratios of Double/Triple/Quad, where the step-up voltage reference power supply
can be input externally)
• High-accuracy voltage adjustment circuit
(Thermal gradient –0.1%/°C)
• V0 voltage divider resistors equipped internally, V1 to V4 voltage divider resistors equipped internally,
electronic volume function equipped internally, voltage follower.
1