PF1101-01
SED15E0 Series
SED15E0 Series
Dot Matrix LCD Driver
■ Support up to 100×132 Display
■ Ultra Low Power Consumption
■ MLS Driving Technology
■ Built-in Power Supply Circuit for LCD
■ OVERVIEW
The SED15E0 Series is a single-chip LCD driver for dot-matrix liquid crystal displays (LCDs) which is directly
connectable to a microprocessor bus. It accepts 8-bit parallel or serial display data directly sent from a micro-
processor and stores it in its built-in display data RAM. It generates LCD drive signals independently of micro-
processor.
The use of the built-in display data RAM of 100 × 132 bits and a one-to-one correspondence between LCD
panel pixel dots and the built-in RAM bits permits implementation of displays with a high degree of freedom.
Incorporating 100 circuits of common outputs and 132 circuits of segment outputs, the SED15E0 Series is
capable of displaying 100 × 132 dots (6 rows of 8 characters in terms of 16 × 16-dot Kanji font, 8 rows of 11
characters iterms of 12 × 12-dot Kanji font). It is possible to extend the display capacity with two chips used in
master and slave mode.
No external clock is required for the display data RAM read/write operations, which allows the driver to operate
with an extremely low current consumption. It also incorporates an LCD power supply with a minimum current
consumption, a resistor for adjusting the line voltage for driving LCDs, and a CR oscillator circuit for display
clock to allow the user to implement a display system of a high-performance handy equipment with a minimum
power consumption and a minimum number of components.
■ FEATURES
■ Direct RAM data displaying using the display data RAM.
RAM data bit = “1”....... Display ON
RAM data bit = “0”....... Display OFF (during normal display)
■ RAM capacity
100 × 132 = 13,200 bits
■ LCD drive circuits
100 common outputs and 132 segment outputs
■ High-speed 8-bit microprocessor interface allowing direct connection to both the 8000 and 6800
■ Serial interface
■ A variety of commands: Read/Write Display Data, Display On/Off, Display normal/reverse, Page Address
Set, Display Starting Line Set, Column Address Set, Power Control Set, Power Save, Discharge, Display all
points ON/OFF, Read-Modify-Write, Segment Driver Direction Select , Electronic volume, n-Line AC Inver-
sion, Duty Ratio Select, Common Output Mode Select, Turn On Built-in Oscillation Circuit and Oscillation
Frequency Select
■ Built-in low-power LCD drive power circuit
■ Built-in CR oscillator circuit (capable of inputting external clocks)
1