■
■
RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany
■
■
■
RSG
■
Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de
ELECTRONIC COMPONENTS
Änderungen vorbehalten / subject to change without notice
1500W Single Output Power Supply
RSP-1500 series
Features :
Universal AC input/Full range
ZVS new technology
AC input active surge current limiting
High efficiency up to 91%
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
Forced air cooling by built-in DC ball bearing fan
Output voltage can be trimmed between 70~100% of the rated output voltage
High power density 8.3W/inch3
Current sharing up to 6000W(3+1)
Alarm signal output
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
SPECIFICATION
MODEL
RSP-1500-5
RSP-1500-12
RSP-1500-15
RSP-1500-24
RSP-1500-27
RSP-1500-48
DC VOLTAGE
5V
12V
15V
24V
27V
48V
RATED CURRENT
CURRENT RANGE
RATED POWER
240A
125A
100A
63A
56A
32A
0 ~ 240A
1200W
150mVp-p
4.5 ~ 5.5V
2.0%
0 ~ 125A
1500W
150mVp-p
10 ~ 13.5V
1.0%
0 ~ 100A
1500W
150mVp-p
13.5 ~ 16.5V
1.0%
0 ~ 63A
1512W
150mVp-p
20 ~ 26.4V
1.0%
0 ~ 56A
1512W
150mVp-p
24 ~ 30V
1.0%
0 ~ 32A
1536W
200mVp-p
43 ~ 56V
1.0%
RIPPLE & NOISE (max.) Note.2
OUTPUT VOLTAGE ADJ. RANGE
VOLTAGE TOLERANCE Note.3
LINE REGULATION
0.5%
0.5%
0.5%
0.5%
0.5%
0.5%
LOAD REGULATION
SETUP, RISE TIME
2.0%
0.5%
0.5%
0.5%
0.5%
0.5%
1500ms, 100ms at full load
10ms at full load
HOLD UP TIME (Typ.)
VOLTAGE RANGE
14ms at full load
16ms at full load
90 ~ 264VAC
47~63Hz
127 ~ 370VDC
FREQUENCY RANGE
POWER FACTOR (Typ.)
0.95/230VAC
80%
0.98/115VAC at full load
87%
INPUT
EFFICIENCY (Typ.)
87%
90%
90%
91%
17A/115VAC
30A/115VAC
<2.0mA / 240VAC
8A/230VAC
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
60A/230VAC
LEAKAGE CURRENT
105 ~135% rated output power
OVERLOAD
Note.5
Protection type : Constant current limiting unit will shut down o/p voltage after 5sec. Re-power on to recover
5.75 ~ 6.75V 13.8 ~ 16.8V 17 ~ 20.5V 27.6 ~ 32.4V 31 ~ 36.5V
Protection type : Shut down o/p voltage, re-power on to recover
95 (TSW2 ) Detect on heatsink of power transistor
57.6 ~ 67.2V
OVER VOLTAGE
OVER TEMPERATURE
PROTECTION
5
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
12V@0.1A(Only for Remote ON/OFF control)
Please see the Function Manual
AUXILIARY POWER(AUX)
REMOTE ON/OFF CONTROL
ALARM SIGNAL OUTPUT
OUTPUT VOLTAGE TRIM
CURRENT SHARING
Please see the Function Manual
FUNCTION
Please see the Function Manual
Please see the Function Manual
-20 ~ +70 (Refer to output load derating curve)
20~90% RH non-condensing
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH
ENVIRONMENT
TEMP. COEFFICIENT
VIBRATION
0.05%/ (0 ~ 50
)
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
UL60950-1, TUV EN60950-1 Approved
SAFETY STANDARDS
WITHSTAND VOLTAGE
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
SAFETY &
ISOLATION RESISTANCE
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC
Compliance to EN55022 (CISPR22)
EMC
(Note 4)
EMI CONDUCTION & RADIATION
HARMONIC CURRENT
Compliance to EN61000-3-2,-3
EMS IMMUNITY
MTBF
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A
62.6K hrs min. MIL-HDBK-217F (25
278*127*83.5mm (L*W*H)
)
OTHERS DIMENSION
PACKING
2.6Kg; 6pcs/16.6Kg/1.54CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
NOTE
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. Derating may be needed under low input voltages. Please check the derating curve for more details.
File Name:RSP-1500-SPEC 2007-03-19