P
ualtek
Q
P
C
200Watts Single Output
QPSF-200 Series
Electronics Corporation
Features:
Universal AC input/ Full range
Built-in active PFC function, PF>0.95
Withstand 300VAC Surge Input for 5 Sec
High Efficiency, up to 90%
Output Protections: OLP/OVP/OTP/SCP
Wide operating ambient temperature (-20°C~70°C)
Free air convection (150W), 20.5CFM forced air (200W)
All using 105°C long life electrolytic capacitors.
100% full load burn-in test
CB
QPSF-200-12
QPSF-200-24
QPSF-200-27
QPSF-200-48
Model
Output Characteristics
DC Output
12V
24V
27V
48V
16.7A
8.4A
7.4A
4.2A
Rated Current
0~12.5A
0~16.7A
≤120mVp-p
≤200mVp-p
10V~14V
2.0%
0~6.25A
0~8.4A
≤200mVp-p
≤200mVp-p
21V~27V
1.0%
0~5.5A
0~7.4A
≤100mVp-p
≤150mVp-p
24.3V~29.7V
1.0%
0~3.2A
0~4.2A
≤120mVp-p
≤240mVp-p
42V~52.8V
1.0%
Current Range(convection) (Note 1)
Current Range(20.5cfm fan) (Note 1)
Ripple and
0~70°C
Noise (Note 2)
-20~0°C
Voltage ADJ. Range
Voltage Accuracy
Line Regulation
Load Regulation
Set-up Time
0.5%
2.0%
0.5%
1.0%
0.5%
1.0%
0.5%
1.0%
≤4s (115VAC input, full load) ≤2s (230VAC input, full load)
≥16ms/150W ≥10ms/200W (115/230VAC input, full load)
Hold-up Time
0.03%/°C
<5.0%
Temperature Coefficient
Overshoot and Undershoot
Input Characteristics
Voltage Range
Frequency Range
90VAC~264VAC, 120VDC~370VDC
47Hz-63Hz
Power Factor (Typical)
PF>0.98/115VAC PF>0.95/230VAC
Efficiency (Typical) 230VAC Input 88.5%
89%
89%
89%
AC Current (max)
Inrush Current (Typical)
Leakage Current
<3.0A
<30A@115VAC Cold start <50A@230VAC Cold start
Input-Output: <0.25mA Input-PG: <3.5mA
Protection
Over Load (OLP)
18A~30A
9A~12A
Protection Type: Hiccup mode, auto recovery
15V~20V
30V~36V
7.77A~11.1A
4.5A~6.3A
55V~70V
31V~40.5V
Over Voltage (OVP)
Protection Type: Hiccup mode, auto recovery
Long-term mode, auto recovery
Short Circuit (SCP)
Environmental Characteristics
Operating Amb. Temp. & Hum
Storage Temp. & Hum
Safety Standards
-20°C~70°C; 20%~90% RH Non-Condensing
-40°C~85°C: 10%-95% RH Non-Condensing
GB4943; EN60950-1: 2006
Withstand Voltage
Primary-Secondary: 3.0KVAC;≤10mA. Primary-PG: 1.5KVAC;≤10mA. Secondary-PG: 0.5KVDC;≤10mA
≥100M ohms
Compliance to EN55022, EN55024(CISPR22) Class B
Compliance to EN61000-3-2, Class D
Isolation Resistance
EMI Conduction & Radiation
Harmonic Current
EMS Immunity
Compliance to EN61000-4-2, 3, 4, 5, 6, 8, 11; ENV55024, light industry level, criteria A
General Characteristics
MTBF (MIL-HDBK-217F)
Dimension (LxWxH)
Packing
More than 100,000Hrs (25°C, Full load)
128x76.5x34.6mm
21PCS/CTN. G.W: 9.4kgs
Cooling Method
Note
Cooling by free air convection (150W Output) / Cooling by forced air (Output 200W)
1. All parameters NOT specially mentioned are measured at rated input, rated load, and 25°C of ambient temperature
2. Measured at 20MHz of bandwith by using a 12” Twisted pair wire terminated with a 0.1uF & 47uF parallel capacitor
3. The SPS is considered a component which will be installed into final equipment. The equipment must be re-confirmed that it still meets EMC directives.
Page 1 of 2