PPG312F
Ò
12-BIT PROGRAMMABLE
PULSE GENERATOR
(SERIES PPG312F)
data
delay
3
devices, inc.
FEATURES
PACKAGES
TRIG
N/C
N/C
N/C
N/C
N/C
N/C
GND
N/C
N/C
GND
A3
1
40
39
38
37
36
35
34
33
32
31
30
29
28
27
26
25
24
23
22
21
VCC
N/C
OUT
OUT/
N/C
RES
N/C
N/C
VCC
A0
2
·
·
·
·
·
·
·
·
·
Digitally programmable in 4096 steps
Monotonic pulse-width-vs-address variation
Rising edge triggered
Two separate outputs: inverting & non-inverting
Precise and stable pulse width
Input & outputs fully TTL interfaced & buffered
10 T2L fan-out capability
3
4
PPG312F-xx
DIP
PPG312F-xxC5
Gull-Wing
PPG312F-xxM
Military DIP
PPG312F-xxMC5
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
A1
A2
Fits standard 40-pin DIP socket
Auto-insertable
A5
N/C
N/C
N/C
N/C
N/C
A4
Military Gull-Wing
A6
A7
GND
A8
A9
A10
A11
N/C
VCC
PIN DESCRIPTIONS
FUNCTIONAL DESCRIPTION
TRIG Trigger Input
The PPG312F-series device is a 12-bit digitally programmable pulse
generator. The width, PWA, depends on the address code (A11-A0)
according to the following formula:
OUT Non-inverted Output
OUT/ Inverted Output
A0-A11 Address Bits
RES
VCC +5 Volts
GND Ground
Reset
PWA = PW0 + TINC * A
where A is the address code, TINC is the incremental pulse width of the
device, and PW0 is the inherent pulse width of the device. The
incremental width is specified by the dash number of the device and can range from 0.5ns through 400ns,
inclusively. RESET is held LOW during normal operation. When it is brought HIGH, OUT and OUT/ are
forced into LOW and HIGH states, respectively, and the unit is ready for the next trigger input. The
address is not latched and must remain asserted while the output pulse is active.
DASH NUMBER SPECIFICATIONS
SERIES SPECIFICATIONS
Part
Number
Incremental Width
Per Step (ns)
.5 ± .3
Total Width
Change (us)
2.048 ± 0.10
4.096 ± 0.20
8.192 ± 0.41
20.48 ± 1.02
40.96 ± 2.05
81.92 ± 4.10
204.8 ± 10.2
409.6 ± 20.5
819.2 ± 41.0
1,638.4 ± 81.9
·
Programmed pulse width tolerance: 5% or 2ns,
whichever is greater
PPG312F-.5
PPG312F-1
PPG312F-2
PPG312F-5
PPG312F-10
PPG312F-20
PPG312F-50
PPG312F-100
PPG312F-200
PPG312F-400
·
·
·
·
·
Inherent width (PW0):20ns typical
Inherent delay (TTO): 10ns ± 2ns
Operating temperature: 0° to 70° C
Supply voltage VCC: 5VDC ± 5%
Supply current: ICC = 200ma typical
1 ± .5
2 ± .5
5 ± 1.5
10 ± 2.0
20 ± 2.0
50 ± 2.5
100 ± 5.0
200 ± 10.0
400 ± 20.0
NOTE: Any dash number between .5 and 400 not
shown is also available.
Ó1997 Data Delay Devices
Doc #97008
DATA DELAY DEVICES, INC.
3 Mt. Prospect Ave. Clifton, NJ 07013
1
1/15/97
Powered by ICminer.com Electronic-Library Service CopyRight 2003