PHxxZG-xxxxE/Z/D2:1(H30)LF
PHxxZG-xxxx E 4:1(H30)LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PHR-SERIES
ꢀ 33 - 75 Watt
Rev.02-2009
ꢀ 2:1 /4:1 (Ultra) Wide Input
ꢀ Reg. Single, Dual, Triple Output
ꢀ 2.6” x 3” Case
The PHR series is a family of cost effective 33 - 60 W, single, dual and
triple output DC/DC converters with a wide 2:1 or 4:1 Input. These
converters are encapsulated in nickel coated copper 2.6”x3” case with
high performance technology like 1.5 up to 3 kV I/O isolation, high
efficiency operation, remote on/off control, short circuit protection,
thermal shutdown, UVLO/OVLO shutdown, soft start and output voltage
accuracy of ±2% / ± 5% typ.
ꢀ 1.5 up to 3 kV DC I/O Isolation
ꢀ
ꢀ
Over Voltage / SC Protection
Soft Start and Remote Ctrl.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
2:1 / 4:1 (Ultra) Wide Input (see table)
PI Type
Output Specifications
Voltage Accuracy
2% (Single/Dual/Tripple)
5% (Auxiliary)
Short Circuit Protection
Over Load Protection
Line Regulation
Continuous (Automatic Recovery)
≥ 110% of Full Load
1%
Load Regulation (25% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
Transient Response Recovery Time
1% (Single), 2% (Dual / Tripple)
≤ 80 mV pk-pk (3.3V, 5V); 1% of Vout (others)
0.05% / °C
280us, max. (50% Load Step Change)
General Specifications
Efficiency
See Table
I/O Isolation Voltage (3 sec.)
I/O Isolation Resistance
Switching Frequency
Humidity
1500 VDC (3000 VDC optional*)
1000 M Ohm
60 kHz, typ.
95% rel H
Reliability Calculated MTBF (MIL-HDBK-217F) > 0.3 MHrs
Physical Specifications
Case Material
Potting Material
Weight
Nickel Coated Copper
Epoxy (UL94V-0 rated)
~ 212g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Thermal Shutdown
Storage Temperature
Cooling
- 40 to +71°C (ambient, max.)
95°C
+105 to +115°C
- 55 to +115°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
RoHS Conform
PHR-Series–PHxxZG-xxxxE/Z/D2:1/4:1(H30)LF–Single, Dual and Triple Output–2.6”x3”-Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/6