CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Radial Lead
●Super low ESR, high ripple current capability
●Downsized from PSC series (φ8×8L toφ6.3×8L)
PSE
●
Endurance is longer life than PSC series (5,000 hours at 105℃)
Longer life
Downsized
●ESR after endurance is specified within the initial spec
●Rated voltage range : 2.5 to 6.3Vdc
●RoHS Compliant
PSC
●Halogen Free
◆SPECIFICATIONS
Items
Characteristics
Category
Temperature Range
-
55 to +105℃
Rated Voltage Range 2.5 to 6.3Vdc
Capacitance Tolerance ±20% (M)
(at 20℃, 120Hz)
(at 105℃)
Surge Voltage
Rated voltage(V)×1.15
=
I 0.2CV or 500µA, whichever is greater
Leakage Current
*Note
Where, I : Max. leakage current (µA), C : Nominal capacitance (µF), V : Rated voltage (V)
(at 20℃ after 2 minutes)
(at 20℃, 120Hz)
Dissipation Factor
(tanδ)
0.10 max.
+
-25℃)/Z( 20℃)≦1.15
Low Temperature
Characteristics
(Max.Impedance Ratio)
Z(
Z(
+
55℃)/Z( 20℃)≦1.25
-
(at 100kHz)
Endurance
The following specifications shall be satisfied when the capacitors are restored to 20℃ after the rated voltage is applied for 5,000 hours
at 105℃.
Appearance
Capacitance change
D.F. (tanδ)
No significant damage
≦±20% of the initial value
≦The initial specified value
≦The initial specified value
≦The initial specified value
ESR
Leakage current
Bias Humidity Test The following specifications shall be satisfied when the capacitors are restored to 20℃ after subjecting them to DC voltage at 60C,
90 to 95% RH for 1,000 hours.
Appearance
Capacitance change
D.F. (tanδ)
No significant damage
≦±20% of the initial value
≦The initial specified value
≦The initial specified value
≦The initial specified value
ESR
Leakage current
Surge Voltage Test The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105℃ for 30 seconds
through a protective resistor(R=1kΩ) and discharge for 5 minutes 30 seconds.
Appearance
Capacitance change
D.F. (tanδ)
No significant damage
≦±20% of the initial value
≦The initial specified value
≦The initial specified value
≦The initial specified value
ESR
Leakage current
Failure Rate
0.5% per 1,000 hours maximum (Confidence level 60% at 105℃)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105℃.
◆DIMENSIONS [mm]
●
Terminal Code : E
Coated Case
F08
Size code
F08
6.3
H06
8.0
◆MARKING
φD
φd
F
φD'
L'
EX) 2.5V820MF
0.6
6D6
2.5
3.5
E
+
φD 0.5max.
820
V
+
L 1.5max.
2.5
L'
15min.
4min.
Coated Case
H06
L'
15min.
4min.
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
(1/2)
CAT. No. E1001L