P6SMB SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
Unit: inch (mm)
5.5 to 214 Volts
SMB/DO-214AA
600 Watts
PEAK PULSE POWER
VOLTAGE
FEATURES
• For surface mounted applications in order to optimize board space.
• Low profile package
• Built-in strain relief
• Glass passivated junction
• Low inductance
• Typical ID less than 1.0µA above 10V
• Plastic package has Underwriters Laboratory
Fammability Classification 94V-O
.185(4.70)
.160(4.06)
.012(.305)
.006(.152)
• High temperature soldering : 260°C /10 seconds at terminals
• In compliance with EU RoHS 2002/95/EC directives
MECHANICAL DATA
.050(1.27)
.030(0.76)
.008(.203)
.002(.051)
• Case: JEDEC DO-214AA ,Molded plastic over passivated junction
• Terminals: Solder plated,solderable per MIL-STD-750,Method 2026
• Polarity: Color band denotes positive end (cathode)
• Standard Packaging:12mm tape (EIA-481)
.220(5.59)
.200(5.08)
• Weight: 0.003 ounce, 0.093 gram
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Symbol
Value
Units
Peak Pulse Power Dissipation on 10/1000uS waveform (Notes 1,2, Fig.1)
PPPM
600
Watts
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
IFSM
IPPM
100
Amps
Amps
OC
Peak Pulse Current on 10/1000us waveform(Note 1)Fig.3
Operating Junction and Storage Temperature Range
see Table 1
-55 to +150
TJ,TSTG
NOTES:
O
1. Non-repetitive current pulse, per Fig.3 and derated above T = 25 C per Fig. 2.
A
2
2. Mounted on 5.0mm (0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute
maximum.
STAD-MAY.25.2007
PAGE . 1