P6SMB SERIES
Surface Mount Transient Voltage Suppressor
Voltage Range
6.8 to 200 Volts
600 Watts Peak Power
SMB/DO-214AA
Features
ꢀ
For surface mounted application in order to optimize board
space
Low profile package
Built-in strain relief
.082(2.08)
.076(1.93)
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
.147(3.73)
.137(3.48)
Glass passivated junction
Excellent clamping capability
Fast response time: Typically less than 1.0ps from 0 volt to
BV min.
.187(4.75)
.167(4.25)
ꢀ
ꢀ
Typical IR less than 1
μ
A above 10V
.012(.31)
.006(.15)
High temperature soldering guaranteed:
250OC / 10 seconds at terminals
ꢀ
ꢀ
Plastic material used carries Underwriters Laboratory
Flammability Classification 94V-0
600 watts peak pulse power capability with a 10 x 1000 us
waveform by 0.01% duty cycle
.103(2.61)
.078(1.99)
.012(.31)
.006(.15)
.056(1.41)
.035(0.90)
.008(.20)
.004(.10)
Mechanical Data
.208(5.28)
.200(5.08)
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Case: Molded plastic
Terminals: Solder plated
Polarity: Indicated by cathode band
Standard packaging: 12mm tape (EIA STD RS-481)
Weight: 0.093gram
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Rating at 25℃ambient temperature unless otherwise specified.
Type Number
Symbol
Value
Units
Peak Power Dissipation at TA=25OC,
Tp=1ms(Note 1)
PPK
Minimum 600
Watts
Peak Forward Surge Current, 8.3 ms Single Half
Sine-wave Superimposed on Rated Load
(JEDEC method) (Note 2, 3) - Unidirectional Only
Maximum Instantaneous Forward Voltage at
50.0A for Unidirectional Only (Note 4)
IFSM
100
Amps
VF
3.5
Volts
OC
Operating and Storage Temperature Range
TJ, TSTG
-65 to + 150
Notes: 1. Non-repetitive Current Pulse Per Fig. 3 and Derated above TA=25OC Per Fig. 2.
2. Mounted on 5.0mm2 (.013 mm Thick) Copper Pads to Each Terminal.
3. 8.3ms Single Half Sine-wave or Equivalent Square Wave, Duty Cycle=4 pulses Per Minute
Maximum.
Devices for Bipolar Applications
1. For Bidrectional Use C or CA Suffix for Types P6SMB6.8 through Types P6SMB200A.
2. Electrical Characteristics Apply in Both Directions.
- 620 -