NCP5425
Dual Synchronous
Buck Controller
The NCP5425 is a highly flexible dual buck controller with internal
gate drivers that can be used with two input power supplies and one or
two outputs in multiple configurations. The part contains all the
circuitry required for two independent synchronous dual NFET buck
regulators utilizing a feed forward voltage mode control method. The
NCP5425 can run from a single supply ranging from 4.6 to 12 volts
and support a single two phase or dual single phase outputs. When
used as a dual output controller, the second output tracks voltage
transients from the first. Power blanking for low noise applications is
supported as well as independent cycle−by−cycle current limiting. The
part is available in a 20 pin TSSOP package allowing the designer to
minimize PCB area.
http://onsemi.com
TSSOP−20
DB SUFFIX
CASE 948E
20
1
PIN CONNECTIONS AND
MARKING DIAGRAM
Features
• Operation Over 4.6 to 13.2 Volts
• Dual Synchronous Buck Design
20
1
GATEH1
GATEL1
GATEH2
GATEL2
• Configurable as a Single Two Phase Output or Two Single Phase
Outputs
GND
BST
NC
NC
IS+1
IS−1
V
R
CC
NCP
5425
AWLYWW
OSC
• Programmable Power Sharing and Budgeting from Two Independent
Supplies
MODE
IS−2
IS+2
V
V
• 0.8 Volt "1% Reference for Low Voltage Outputs
• 1.5 A Peak Power Drive
REF2
V
FB1
FB2
COMP1
COMP2
• Switch Blanking for Noise Sensitive Applications through use of
R
OSC
Pin
A
= Assembly Location
WL = Wafer Lot
= Year
WW = Work Week
• Programmable Frequency, 150 kHz to 750 kHz Operation
• Programmable Soft Start
• Cycle−by−Cycle Overcurrent Protection
• Independent Programmable Current Limits
• 100% Duty Cycle for Fast Transient Response
• Internal Slope Compensation
Y
ORDERING INFORMATION
†
Device
Package
Shipping
61 Units/Rail
• Out−of−Phase Synchronization between the Controllers
• Input Undervoltage Lockout
NCP5425DB
TSSOP−20
TSSOP−20
2500 Units/Reel
NCP5425DBR2
• On/Off Enable through use of the COMP Pins
• Power Supply Sequencing
†For information on tape and reel specifications,
including part orientation and tape sizes, please
refer to our Tape and Reel Packaging Specification
Brochure, BRD8011/D.
Applications
• DDR Memory Power
• Graphics Cards
Semiconductor Components Industries, LLC, 2005
1
Publication Order Number:
January, 2005 − Rev. 6
NCP5425/D