Document Number: MMPF0100Z
Rev. 12.0, 8/2016
NXP Semiconductors
Data sheet: Advance Information
14 channel configurable power
management integrated circuit
PF0100Z
Automotive
The SMARTMOS PF0100Z AEC Q100 grade 2 automotive power management
integrated circuit (PMIC) provides a highly programmable/ configurable
architecture, with fully integrated power devices and minimal external
components. With up to six buck converters, six linear regulators, RTC supply,
and coin-cell charger, the PF0100Z can provide power for a complete system,
including applications processors, memory, and system peripherals, in a wide
range of applications. With on-chip one time programmable (OTP) memory, the
PF0100Z is available in pre-programmed standard versions, or non-
programmed to support custom programming. The PF0100Z is especially suited
to the i.MX 6 family of devices and is supported by full system level reference
designs, and pre-programmed versions of the device.
POWER MANAGEMENT
ES SUFFIX (WF-TYPE)
98ASA00589D
56 QFN 8X8
Features:
Applications:
• Four to six buck converters, depending on configuration
• GPS
• Auto infotainment
•
•
Single/dual phase/ parallel options
DDR termination tracking mode option
• Heads up display (HUD)
• Rear displays
• Digital instrumentation cluster (DIC)
• Boost regulator to 5.0 V output
• Six general purpose linear regulators
• Programmable output voltage, sequence, and timing
• OTP (one time programmable) memory for device configuration
• Coin cell charger and RTC supply
• DDR termination reference voltage
• Power control logic with processor interface and event detection
• I2C control
• Individually programmable on, off, and standby modes
PF0100Z
i.MX 6X
VREFDDR
DDR MEMORY
INTERFACE
DDR Memory
SW4
1000 mA
SW3A/B
2500 mA
SW1A/B
2500 mA
Processor Core
Voltages
SW1C
2000 mA
External AMP
Microphones
Speakers
SW2
2000 mA
SATA - FLASH
SD-MMC/
NAND Mem.
SATA
HDD
NAND
- NOR
SWBST
600 mA
Interfaces
Audio
Codec
Parallel control/GPIOS
I2C Communication
Control Signals
I2C Communication
Sensors
VGEN1
100 mA
Camera
Camera
VGEN2
250 mA
GPS
MIPI
uPCIe
WAM
GPS
MIPI
VGEN3
100 mA
VGEN4
350 mA
HDMI
LDVS Display
VGEN5
100 mA
USB
Ethernet
CAN
LICELL
Charger
VGEN6
200 mA
Main Supply
2.8 – 4.5 V
COINCELL
Front USB
POD
Rear Seat
Infotaiment
Rear USB
POD
Cluster/HUD
Figure 1. Simplified application diagram
* This document contains certain information on a new product.
Specifications and information herein are subject to change without notice.
© 2016 NXP B.V.