Document Number: MMPF0100
Rev. 18, 7/2019
NXP Semiconductors
Data sheet: Technical Data
14 channel configurable power
management integrated circuit
PF0100
The PF0100 SMARTMOS power management integrated circuit (PMIC)
provides a highly programmable/ configurable architecture, with fully integrated
power devices and minimal external components. With up to six buck
converters, six linear regulators, RTC supply, and coin-cell charger, the
PF0100 can provide power for a complete system, including applications
processors, memory, and system peripherals, in a wide range of applications.
With on-chip one time programmable (OTP) memory, the PF0100 is available
in pre-programmed standard versions, or non-programmed to support custom
programming. The PF0100 is defined to power an entire embedded MCU
platform solution such as i.MX 6 based eReader, IPTV, medical monitoring, and
home/factory automation.
POWER MANAGEMENT
EP SUFFIX (E-TYPE)
ES SUFFIX (WF-TYPE)
98ASA00589D
98ASA00405D
56 QFN 8X8
56 QFN 8X8
Features:
Applications:
• Four to six buck converters, depending on configuration
• Tablets
• IPTV
•
•
Single/Dual phase/ parallel options
DDR termination tracking mode option
• eReaders
• Boost regulator to 5.0 V output
• Set top boxes
• Industrial control
• Medical monitoring
• Six general purpose linear regulators
• Programmable output voltage, sequence, and timing
• OTP (one time programmable) memory for device configuration
• Coin cell charger and RTC supply
• Home automation/ alarm/ energy management
• DDR termination reference voltage
• Power control logic with processor interface and event detection
• I2C control
• Individually programmable ON, OFF, and standby modes
PF0100
i.MX 6X
VREFDDR
DDR MEMORY
INTERFACE
DDR Memory
SW4
1000 mA
SW3A/B
2500 mA
SW1A/B
2500 mA
Processor Core
Voltages
SW1C
2000 mA
External AMP
Microphones
Speakers
SW2
2000 mA
SATA - FLASH
SD-MMC/
NAND Mem.
SATA
HDD
NAND
- NOR
SWBST
600 mA
Interfaces
Audio
Codec
Parallel control/GPIOS
I2C Communication
Control Signals
I2C Communication
Sensors
VGEN1
100 mA
Camera
Camera
VGEN2
250 mA
GPS
MIPI
uPCIe
WAM
GPS
MIPI
VGEN3
100 mA
VGEN4
350 mA
HDMI
LDVS Display
VGEN5
100 mA
USB
Ethernet
CAN
LICELL
Charger
VGEN6
200 mA
Main Supply
2.8 – 4.5 V
COINCELL
Front USB
POD
Rear Seat
Infotaiment
Rear USB
POD
Cluster/HUD
Figure 1. Simplified application diagram
© NXP B.V. 2019.