MIC23650
6A Step-Down Converter
with HyperLight Load™ and Output Voltage Select
Features
General Description
• 2.4V to 5.5V Input Voltage Range
• 6A (Pulsed) Output Current
The MIC23650 is a high-efficiency, low-voltage, 6A
peak synchronous step-down regulator. The
Constant-ON-Time (COT) control architecture with
HyperLight Load™ provides very high efficiency at light
loads, while still having ultra fast transient response.
• Pin Strapping Voltage Selection:
- Three-State pins (nine voltage options)
- 0.6V, 0.8V, 0.9V, 1.0V, 1.2V, 1.5V, 1.8V, 2.5V
or 3.3V output voltage
The MIC23650 output voltage is set by two VSEL
(Voltage Selection) pins, between nine different values.
This method eliminates the need for an external
feedback resistor divider and improves the output
voltage setting accuracy.
• Reduced Component Count (No Feedback
Resistors)
• High Efficiency (up to 95%)
• Output Discharge when Disabled
The 2.4V to 5.5V input voltage range, low shutdown
and quiescent currents make the MIC23650 ideal for
single-cell Li-Ion battery-powered applications. The
100% duty cycle capability provides low dropout
operation, extending operating range in portable
systems.
• Constant-ON-Time Control with High Switching
Frequency:
- 1.2 MHz typical at 1.0V output voltage
• ±1.5% Output Voltage Accuracy Over
Line/Load/Temperature Range
• 0.8 ms/V Soft Start Speed
The MIC23650 pinout is compatible with the MIC23656
I2C-based programmable regulator version, such that
applications can be easily converted. An open-drain
Power Good output is provided to indicate when the
output voltage is within 9% of regulation and facilitates
the interface with an MCU, or power sequencing. If set
in shutdown (EN=GND), the MIC23650 typically draws
1.5 µA, while the output is discharged through 10
pull-down.
• Supports Safe Start-Up with Pre-Biased Output
• Typical 1.5 µA Shutdown Supply Current
• Low Dropout Operation (100% Duty Cycle)
• Ultra Fast Transient Response
• Latch-Off Thermal Shutdown Protection
• Latch-Off Current Limit Protection
• Power Good (PG) Open-Drain Output
The MIC23650 is available in a thermally efficient, 16
Lead 2.5 mm x 2.5 mm x 0.55 mm thin FTQFN
package, with an operating junction temperature range
from –40°C to +125°C.
Applications
• Solid State Drives (SSD)
• FPGAs, DSP and Low-Voltage ASIC Power
2018-2019 Microchip Technology Inc.
DS20006098B-page 1