EVALUATION KIT AVAILABLE
MAX5098A
Dual 2.2MHz Buck or Boost Converter
with 80V Load-Dump Protection
General Description
Features
The MAX5098A is
a dual-output, high-switching-
● Wide 4.5V to 5.5V or 5.2V to 19V Input Voltage
frequency DC-DC converter with integrated n-channel
switches that can be used either in high-side or low-
side configuration. Each output can be configured either
as a buck converter or a boost converter. In the buck
configuration, this device delivers up to 2A from
converter 1 and 1A from converter 2. The MAX5098A also
integrates a load-dump protection circuitry that is capable
of handling load-dump transients up to 80V for industrial
applications. The load-dump protection circuit utilizes
an internal charge pump to drive the gate of an external
n-channel MOSFET. When an overvoltage or load-dump
condition occurs, the series protection MOSFET absorbs
the high-voltage transient to prevent damage to lower-
voltage components.
Range (with Up to 80V Load-Dump Protection)
● Dual-Output DC-DC Converter with Integrated Power
MOSFETs
● Each Output Configurable in Buck or Boost Mode
● Adjustable Outputs from 0.8V to 0.85V Buck
IN
Configuration) and from V to 28V (Boost
IN
Configuration)
● I
and I
of 2A and 1A (Respectively) in
OUT1
OUT2
Buck Configuration
● Switching Frequency Programmable from 200kHz to
2.2MHz
● Synchronization Input (SYNC)
The DC-DC converters operate over a wide operating
voltage range from 4.5V to 19V. The MAX5098A operates
180° out-of-phase with an adjustable switching frequency
to minimize external components while allowing the ability
to make trade-offs between the size, efficiency, and cost.
● Clock Output (CKO) for Four-Phase Master-Slave
Operation
● Individual Converter Enable Input and Power-Good
Output
This device utilizes voltage-mode control for stable
operation and external compensation; thus, the loop gain
is tailored to optimize component selection and transient
response. This device can be synchronized to an external
clock fed at the SYNC input. Also, a clock output (CKO)
allows a master-slave connection of two devices with a
four-phase synchronized switching sequence. Additional
features include internal digital soft-start, individual enable
for each DC-DC regulator (EN1 and EN2), open-drain
power-good outputs (PGOOD1 and PGOOD2), and a
shutdown input (ON/OFF).
● Low-I (7µA) Standby Current (ON/OFF)
Q
● Internal Digital Soft-Start and Soft-Stop
● Short-Circuit Protection on Outputs and Maximum
Duty-Cycle Limit
● Overvoltage Protection on Outputs with Auto Restart
● Thermal Shutdown
● Thermally Enhanced 32-Pin TQFN Package
Dissipates Up to 2.7W at +70°C
Ordering Information
Other features of the MAX5098A include overvolt-
age protection, short-circuit (hiccup current limit), and
thermal protection. The MAX5098A is available in
a thermally enhanced, exposed pad, 5mm x 5mm,
32-pin TQFN package and is fully specified over the
-40°C to +125°C temperature range.
PART
TEMP RANGE
PIN-PACKAGE
MAX5098AATJ+
-40°C to +125°C
32 TQFN-EP*
+Denotes a lead(Pb)-free/RoHS-compliant package.
*EP = Exposed pad.
Applications
● Industrial
Pin Configuration appears at end of data sheet.
19-4111; Rev 1; 10/14