EVALUATION KIT AVAILABLE
Click here to ask about the production status of specific part numbers.
MAX22005
12-Channel Factory-Calibrated
Configurable Industrial-Analog Input
General Description
Benefits and Features
The MAX22005 is a twelve-channel industrial-grade ana-
log input voltage-mode device that can also be configured
as analog-input current-mode device using an external
precision resistor per channel. It can also operate as con-
figurable analog-input using an external precision resistor
and low-cost switch per channel. Input channels can be
used as twelve single-ended inputs, or six differential in-
puts, or up to eight multichannel configurable differential
inputs. In total, the device supports up to 26 different con-
figurations.
● Enables More Robust and Reliable Systems
• ±36V High-Voltage Protection for All Input Ports
• 2kV HBM ESD Protection of All Pins
• ±2kV Surge Protection (with External 5kΩ Resistor)
• CRC Detection for Robust Serial Communication
• Watchdog Timer
● Software Configurability
• ±12.5V Analog Input-Voltage Mode
• ±25mA Analog Input-Current Mode Using External
Sense Resistor
The MAX22005 features an integrated 24-bit delta-sigma
ADC that is shared between all channels. The ADC can
be used with either an integrated 5ppm/°C precision refer-
ence or an external reference. Standard industrial analog
input voltage ranges are converted to the ADC input volt-
age range using high-voltage, zero-drift input amplifiers.
All input ports are robustly protected up to ±36V reverse
polarity and ±2kV surge pulses without the need of TVS
diodes.
• Configurable Inputs Using External Sense Resistor
and Low-Cost Switches
● Best-in-Class System Accuracy
• 0.02% FSR at 25°C Factory Calibrated
• 0.05% FSR over ±50°C from 25°C Factory
Calibration
• Maximum of 30nA Input Leakage
• 5ppm/°C Internal Reference
● Additional Features
Eight general-purpose digital I/O (GPIO) ports are avail-
able for common use, or they can be used to control ex-
ternal switches for configurable inputs.
• Internal or External ADC Reference
• Eight GPIO Ports
• 48.5mW Low Power Dissipation with ±5V Supply
• 30MHz SPI/QSPI/DSP-Compatible Serial Interface
The MAX22005 is factory calibrated with best-in-class sys-
tem performance of less than 0.05% FSR Total-Unadjust-
ed-Error (TUE) over temperature.
● Operating Temperature -40°C to +125°C
● 7.5mm × 7mm 48-pin LGA package
The host communicates with the MAX22005 through a
high-speed 30MHz SPI bus for all configurations and infor-
mation management, as well as for acquiring conversion
results. An optional 8-bit CRC enhances the reliability of
the SPI interface, protecting against all 8-bit bursts, as well
as all double-bit errors.
Ordering Information appear at end of datasheet.
The MAX22005 operates from 2.7V to 3.6V analog and
digital supplies, and up to ±24V high-voltage supplies.
The MAX22005 is available in 48-pin LGA package and
operates over the -40°C to +125°C industrial temperature
range.
Applications
● Programmable Logic Controllers (PLC)
● Programmable Automation Controllers (PAC)
● Distributed Control Systems (DCS)
19-101026; Rev 0; 4/21