5秒后页面跳转
LMS1487EIM PDF预览

LMS1487EIM

更新时间: 2024-10-31 21:53:55
品牌 Logo 应用领域
美国国家半导体 - NSC 总线收发器
页数 文件大小 规格书
13页 247K
描述
Low Power RS-485 / RS-422 Differential Bus Transceiver

LMS1487EIM 数据手册

 浏览型号LMS1487EIM的Datasheet PDF文件第2页浏览型号LMS1487EIM的Datasheet PDF文件第3页浏览型号LMS1487EIM的Datasheet PDF文件第4页浏览型号LMS1487EIM的Datasheet PDF文件第5页浏览型号LMS1487EIM的Datasheet PDF文件第6页浏览型号LMS1487EIM的Datasheet PDF文件第7页 
November 2003  
LMS1487E  
Low Power RS-485 / RS-422 Differential Bus Transceiver  
General Description  
Features  
n Meet ANSI standard RS-485 and RS-422  
n Data rate 2.5 Mbps  
The LMS1487E is a low power differential bus/line trans-  
ceiver designed for high speed bidirectional data communi-  
cation on multipoint bus transmission lines. It is designed for  
balanced transmission lines. It meets ANSI Standards TIA/  
EIA RS422-B, TIA/EIA RS485-A and ITU recommendation  
and V.11 and X.27. The driver outputs and receiver inputs  
have 15kV ESD protection. The LMS1487E combines a  
n Single supply voltage operation, 5V  
n Wide input and output voltage range  
n Thermal shutdown protection  
n Short circuit protection  
n Low quiescent current 660µA (max)  
n Allows up to 128 transceivers on the bus  
n Open circuit fail-safe for receiver  
n Extended operating temperature range −40˚C to 85˚C  
n Drop-in replacement to MAX1487E  
n Available in 8-pin SOIC and 8-pin DIP packages  
TRI-STATE differential line driver and differential input re-  
ceiver, both of which operate from a single 5.0V power  
supply. The driver and receiver have an active high and  
active low, respectively, that can be externally connected to  
function as a direction control. The driver outputs and re-  
ceiver inputs are internally connected to form a differential  
input/output (I/O) bus port that is designed to offer minimum  
loading to bus whenever the driver is disabled or when VCC  
= 0V. These ports feature wide positive and negative com-  
mon mode voltage ranges, making the device suitable for  
multipoint applications in noisy environments. The  
LMS1487E is available in 8-Pin SOIC and 8-pin DIP pack-  
ages. It is a drop-in replacement to Maxim’s MAX1487E.  
Applications  
n Low power RS-485 systems  
n Network hubs, bridges, and routers  
n Point of sales equipment (ATM, barcode scanners,…)  
n Local area networks (LAN)  
n Integrated service digital network (ISDN)  
n Industrial programmable logic controllers  
n High speed parallel and serial applications  
n Multipoint applications with noisy environment  
Typical Application  
20085601  
A typical multipoint application is shown in the above figure. Terminating resistor, RT are typically required but only located at the two ends of the cable.  
Pull-up and pull-down resistors maybe required at the end of the bus to provide fail-safe biasing. The biasing resistors provide a bias to the cable when all  
drivers are in TRI-STATE, See National Application Note, AN-847 for further information.  
© 2003 National Semiconductor Corporation  
DS200856  
www.national.com  

与LMS1487EIM相关器件

型号 品牌 获取价格 描述 数据表
LMS1487EIM/NOPB TI

获取价格

LINE TRANSCEIVER, PDSO8, SOIC-8
LMS1487EIMX NSC

获取价格

Low Power RS-485 / RS-422 Differential Bus Transceiver
LMS1487EIMX/NOPB TI

获取价格

LINE TRANSCEIVER, PDSO8, SOIC-8
LMS1487EINA NSC

获取价格

Low Power RS-485 / RS-422 Differential Bus Transceiver
LMS1487IM NSC

获取价格

5V Low Power RS-485 / RS-422 Differential Bus Transceiver
LMS1487IM/NOPB ROCHESTER

获取价格

LINE TRANSCEIVER, PDSO8, SOIC-8
LMS1487IMX NSC

获取价格

5V Low Power RS-485 / RS-422 Differential Bus Transceiver
LMS1487INA NSC

获取价格

5V Low Power RS-485 / RS-422 Differential Bus Transceiver
LMS1585 NSC

获取价格

5A and 3A Low Dropout Fast Response Regulators
LMS1585A NSC

获取价格

5A and 3A Low Dropout Fast Response Regulators