LF200EDSeries
Low Cost, 2W SMT
Dual Output
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Key Features:
Parameter
Conditions
Min.
Typ.
5.0
Max.
5.5
Units
VDC
A
• 2W Output Power
• Ultra-Miniature SMT Case
• 1,000 VDC Isolation
• -40ºC to +85ºC Operation
• Dual Output
5 VDC Input
4.5
Input Voltage Range
12 VDC Input 10.8
12.0
13.2
1.0
Reverse Polarity Input Current
Input Filter
Capacitor
Output
• Low 0.24” Profile
Parameter
Conditions
Min.
Typ.
Max.
Units
%
• >3.5 MHour MTBF
• Industry Standard Pin-Out
• LOWEST COST!
Output Voltage Accuracy
Line Regulation
Load Regulation
Output Ripple (20 MHz)
Output Noise (20 MHz)
Temperature Coefficient
Output Short Circuit
General
±3.0
For Vin Change of 1%
For Iout = 10% to 100%
±1.2
±15
%
±±
±5
%
150
mV P - P
mV P - P
%/ºC
150
250
±0.03
Momentary (0.5 Sec.)
Parameter
Conditions
Conditions
Min.
60 Seconds 1,000
500 VDC 1,000
100 kHz, 1V
Typ.
Max.
Units
VDC
MΩ
pF
Isolation Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
Environmental
Parameter
±0
±0
kHz
Min.
Typ.
Max.
+85
Units
ºC
Operating Temperature Range
Storage Temperature Range
Cooling
Ambient
-40
-55
+25
+125
ºC
Free Air Convection
RH, Non-condensing
Humidity
95
%
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 020±2
USA
Physical
Case Size
0.±0 x 0.±2 x 0.24 Inches (1±.±8 x 18.03 x 6.0 mm)
Non-Conductive Black Plastic (UL94-V0)
0.05 Oz (1.5g)
Case Material
Weight
T: (±81) 344-8226
F: (±81) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Reliability Specifications
Parameter
Conditions
Min.
Typ.
Typ.
Max.
Units
MTBF
MIL HDBK 21±F, 25ºC, Gnd Benign
3.5
MHours
Absolute Maximum Ratings
Parameter
Conditions
5 VDC Input
Min.
-0.±
-0.±
Max.
±.0
Units
Input Voltage Surge (1 Sec)
VDC
12 VDC Input
15.0
260.0
450
Lead Temperature
1.5 mm From Case For 10 Sec
All Models
ºC
Internal Power Dissipation
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.