5秒后页面跳转
JBL702 PDF预览

JBL702

更新时间: 2024-11-18 01:11:35
品牌 Logo 应用领域
SLPOWER /
页数 文件大小 规格书
2页 242K
描述
Li-ion/Polymer Chargers

JBL702 数据手册

 浏览型号JBL702的Datasheet PDF文件第2页 
JBL702A Series  
Universal Input, 20 Watt Output  
Li-ion/Polymer Chargers  
2 Year Warranty  
100-240VAC Universal Input  
Optimizes Li-ion/Polymer Battery Life  
4V to 21V Output Models, up to 21W  
Dual-color LED Indicator  
Modified and Custom Designs Available  
Impact-Resistant Polycarbonate Enclosure  
Meets safety agency requirements  
Specifications  
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.  
Topology  
Switching – Battery Charger  
AC Input  
100-240VAC, +/-10%, 47-63 Hz, 1.  
Input Current  
1.0A maximum, at 110Vac Approvals and Safety Standards  
EN/IEC/CSA/UL60950-1,  
EMC: EN55022/55024/61000  
Inrush Current  
peak.  
Inrush limiting provided – 150A Dielectric Withstand  
Input-Output: 3000Vac, Input-GND: 1500Vac,  
Output-GND: 500Vdc  
Input Fuse  
Dual Internal Primary Current Fuse: 250Vac, 1A  
See chart.  
Operating Temperature  
Storage Temperature  
0° to 40°C, no derating  
Output Voltage  
Output Power  
Minimum Load  
Battery Type:  
Charging Method:  
-30 to +85°C.  
See chart Relative Humidity  
Not required. Altitude  
5% to 95%, non-condensing  
0 to 10,000 ft.  
Li-ion/Polymer MTBF  
>61,000 hours (calculated)  
Constant current and constant voltage. Case Dimensions:  
4.49”(L) x 2.36”(W) x 1.38(H)”,  
114mm(L) x 60mm(W) x 35mm(H)  
Overload Protection  
Hiccup Mode Case Material:  
Black 94V0 Polycarbonate  
Short Circuit Protection  
Hiccup Mode Output Connections:  
Cable: 1500mm, 18AWG, 2 conductor.  
Connector: 1.35 x 3.5mm barrel type, center contact (+).  
Pre-Charge Mode Operation:  
(a) Threshold Voltage: <10.0 +/-0.2V  
(b) Pre-charge Current = Fast charge current  
(c) Pre-charge Cycle 10 Times, 10sec ON / 2sec OFF  
(d) Fast charge Mode change When the battery voltage is more than 5.0V (Threshold voltage), change to the Fast charge Mode.  
(e) Pre-charge Failure check After 10 cycle, check the battery voltage is less than 5.0V, show the flickering LED; more than 5.0V, change to the Fast  
charge Mode.  
LED Indicators:  
LED Off:  
R/G/A 0.5 second on/off:  
Red LED On:  
Battery Unloaded, output shorted.  
Power switch ON, or reset microcontroller.  
Fast Charge, pre-charge  
Green LED On:  
Flickering Red LED:  
Fully Charged or Trickle Charge  
Error (Output overvoltage or undervoltage. LED error blink rate is 500 mSec on, 500 mSec off.  
______________________________________________________________________________________________________________________________ 1 of 2  
SL Power Electronics Corp 6050 King Drive Ventura, CA 93003 Phone 805.486.4565 Fax 858.712.2040 Email: info@slpower.com www.slpower.com  

与JBL702相关器件

型号 品牌 获取价格 描述 数据表
JBL702A082000003FK SLPOWER

获取价格

Li-ion/Polymer Chargers
JBL702A161200203FC SLPOWER

获取价格

Li-ion/Polymer Chargers
JBL745 SLPOWER

获取价格

Sealed Lead Acid Fast Chargers
JBL7452065000003FJ SLPOWER

获取价格

Sealed Lead Acid Fast Chargers
JBL7452122500003FJ SLPOWER

获取价格

Sealed Lead Acid Fast Chargers
JBL7452241500003FJ SLPOWER

获取价格

Sealed Lead Acid Fast Chargers
JBP18S030 TI

获取价格

256 BITS (32 WORDS BY 8 BITS) PROGRAMMABLE READ-ONLY MEMORIES
JBP18S030MJ TI

获取价格

256 BITS (32 WORDS BY 8 BITS) PROGRAMMABLE READ-ONLY MEMORIES
JBP18S030MW TI

获取价格

256 BITS (32 WORDS BY 8 BITS) PROGRAMMABLE READ-ONLY MEMORIES
JBP18S42MJ TI

获取价格

IC,PROM,512X8,TTL,DIP,20PIN,CERAMIC