5秒后页面跳转
ISO5451DW PDF预览

ISO5451DW

更新时间: 2024-10-01 01:13:35
品牌 Logo 应用领域
德州仪器 - TI 驱动双极性晶体管光电二极管接口集成电路驱动器
页数 文件大小 规格书
38页 1592K
描述
High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Active Safety Features

ISO5451DW 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active包装说明:SOP, SOP16,.4
Reach Compliance Code:compliantECCN代码:EAR99
Factory Lead Time:6 weeks风险等级:1.22
其他特性:ALSO REQUIRED VEE2 SUPPLY -15V TO 0V高边驱动器:NO
接口集成电路类型:AND GATE BASED IGBT/MOSFET DRIVERJESD-30 代码:R-PDSO-G16
JESD-609代码:e4长度:10.3 mm
湿度敏感等级:2功能数量:1
端子数量:16最高工作温度:125 °C
最低工作温度:-40 °C最大输出电流:5 A
标称输出峰值电流:5 A输出极性:TRUE
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装等效代码:SOP16,.4封装形状:RECTANGULAR
封装形式:SMALL OUTLINE电源:3.3/5 V
认证状态:Not Qualified座面最大高度:2.65 mm
子类别:Peripheral Drivers最大压摆率:4.5 mA
最大供电电压:5.5 V最小供电电压:3 V
标称供电电压:5 V电源电压1-最大:30 V
电源电压1-分钟:15 V表面贴装:YES
温度等级:AUTOMOTIVE端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL断开时间:0.11 µs
接通时间:0.11 µs宽度:7.5 mm
Base Number Matches:1

ISO5451DW 数据手册

 浏览型号ISO5451DW的Datasheet PDF文件第2页浏览型号ISO5451DW的Datasheet PDF文件第3页浏览型号ISO5451DW的Datasheet PDF文件第4页浏览型号ISO5451DW的Datasheet PDF文件第5页浏览型号ISO5451DW的Datasheet PDF文件第6页浏览型号ISO5451DW的Datasheet PDF文件第7页 
Sample &  
Buy  
Support &  
Community  
Product  
Folder  
Tools &  
Software  
Technical  
Documents  
ISO5451  
SLLSEO1B JUNE 2015REVISED DECEMBER 2015  
ISO5451 High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver  
with Active Safety Features  
1 Features  
3 Description  
The ISO5451 is a 5.7-kVRMS, reinforced isolated gate  
1
50-kV/μs Minimum and 100-kV/μs Typical  
Common-Mode Transient Immunity (CMTI)  
at VCM = 1500 V  
driver for IGBTs and MOSFETs with 2.5-A source  
and 5-A sink current. The input side operates from a  
single 3-V to 5.5-V supply. The output side allows for  
a supply range from minimum 15-V to maximum  
30-V. Two complementary CMOS inputs control the  
output state of the gate driver. The short propagation  
time of 76 ns assures accurate control of the output  
stage.  
2.5-A Peak Source and 5-A Peak Sink Currents  
Short Propagation Delay: 76 ns (Typ),  
110 ns (Max)  
2-A Active Miller Clamp  
Output Short-Circuit Clamp  
An internal desaturation (DESAT) fault detection  
recognizes when the IGBT is in an overload  
condition. Upon a DESAT detect the gate driver  
output is driven low to VEE2 potential turning the IGBT  
immediately off.  
Fault Alarm upon Desaturation Detection is  
Signaled on FLT and Reset Through RST  
Input and Output Under Voltage Lock-Out (UVLO)  
with Ready (RDY) Pin Indication  
Active Output Pull-down and Default Low Outputs  
with Low Supply or Floating Inputs  
When desaturation is active, a fault signal is sent  
across the isolation barrier pulling the FLT output at  
the input side low and blocking the isolator input. The  
FLT output condition is latched and can be reset  
through a low-active pulse at the RST input.  
3-V to 5.5-V Input Supply Voltage  
15-V to 30-V Output Driver Supply Voltage  
CMOS Compatible Inputs  
When the IGBT is turned off during normal operation  
with bipolar output supply, the output is hard clamp to  
VEE2. If the output supply is unipolar, an active Miller  
clamp can be used, allowing Miller current to sink  
across a low impedance path preventing IGBT to be  
dynamically turned on during high voltage transient  
conditions.  
Rejects Input Pulses and Noise Transients  
Shorter Than 20 ns  
Operating Temperature: –40°C to 125°C Ambient  
Isolation Surge Withstand Voltage 10000-VPK  
Safety and Regulatory Certifications:  
8000-VPK VIOTM and 1420-VPK VIORM  
Reinforced Isolation per DIN V VDE V 0884-10  
(VDE V 0884-10):2006-12  
Device Information(1)  
PART NUMBER  
PACKAGE  
BODY SIZE (NOM)  
5700-VRMS Isolation for 1 Minute per UL 1577  
ISO5451  
SOIC (16)  
10.30 mm × 7.50 mm  
CSA Component Acceptance Notice 5A, IEC  
60950-1, IEC 60601-1 and IEC 61010-1 End  
Equipment Standards  
(1) For all available packages, see the orderable addendum at  
the end of the datasheet.  
Functional Block Diagram  
CQC Certification per GB4943.1-2011  
All Certifications are Planned  
2 Applications  
Isolated IGBT and MOSFET Drives in  
Industrial Motor Control Drives  
Industrial Power Supplies  
Solar Inverters  
L{h5451  
OUT  
HEV and EV Power Modules  
Induction Heating  
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,  
intellectual property matters and other important disclaimers. PRODUCTION DATA.  
 
 
 
 
 
 
 

ISO5451DW 替代型号

型号 品牌 替代类型 描述 数据表
ISO5451DWR TI

完全替代

High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Active Safety Features

与ISO5451DW相关器件

型号 品牌 获取价格 描述 数据表
ISO5451DWR TI

获取价格

High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Active Safety Features
ISO5451-Q1 TI

获取价格

具有有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动器
ISO5451QDWQ1 TI

获取价格

具有有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动器 | D
ISO5451QDWRQ1 TI

获取价格

具有有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动器 | D
ISO5452 TI

获取价格

High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Split Outputs and Active Safe
ISO5452DW TI

获取价格

High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Split Outputs and Active Safe
ISO5452DWR TI

获取价格

High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver with Split Outputs and Active Safe
ISO5452-Q1 TI

获取价格

具有分离输出和有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动
ISO5452QDWQ1 TI

获取价格

具有分离输出和有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动
ISO5452QDWRQ1 TI

获取价格

具有分离输出和有源保护功能的汽车类 5.7kVrms、2.5A/5A 单通道隔离式栅极驱动