Complete Current Share 10A DC/DC Power Module
ISL8200M
Features
• Complete Switch Mode Power Supply in One Package
The ISL8200M is a simple and easy to use high power,
current-sharing DC\DC power module for
Datacom\Telecom\FPGA power hungry applications. All
that is needed is the ISL8200M, a few passive
• Patented Current Share Architecture Reduces Layout
Sensitivity When Modules are Paralleled
• Programmable Phase Shift (1 to 6 phase)
• Extremely Low Profile (2.2mm height)
components and one V
complete 10A design ready for market.
setting resistor to have a
OUT
• Input Voltage Range +3.0 V to +20V at 10A, Current
Share up to 60A
The ease of use virtually eliminates the design and
manufacturing risks while dramatically improving time
to market.
• A Single Resistor Sets V
from +0.6V to +6V
OUT
• Output Overvoltage, Overcurrent and
Over-Temperature, Built-in Protection and
Undervoltage indication
Need more output current? Just simply parallel up to six
ISL8200M modules to scale up to a 60A solution (see
Page 7, Figure 6).
The simplicity of the ISL8200M is in its "Off The Shelf",
unassisted implementation. Patented current sharing
in multi-phase operation greatly reduces ripple
currents, BOM cost and complexity.
Applications*(see page 21)
• Servers, Telecom and Datacom Applications
• Industrial and Medical Equipment
• Point of Load Regulation
The ISL8200M’s thermally enhanced, compact QFN
package, operates at full load and over-temperature,
without requiring forced air cooling. It's so thin it can
even fit on the back side of the PCB. Easy access to all
pins with few external components, reduces the PCB
design to a component layer and a simple ground
layer.
Related Literature*(see page 21)
• AN1544 ISL8200MEVAL2PHZ Evaluation Board
User’s Guide
• iSim Model - (See Respective Device Information
Page at http//:www.intersil.com
)
Complete Functional Schematic ISL8200M Package
VOUT Range
0.6V to 6.0V
VIN Range
3V to 20V
VOUT
VIN
PVIN
ISL8200M
Power
RSET
2.2mm
Module
VOUT_SET
VEN
EN
FF
VSEN_REM
PGND1
10 F
-
ISHARE
5k
FIGURE 1. COMPLETE 10A DESIGN, JUST SELECT R
SET
FIGURE 2. THE 2.2mm HEIGHT IS IDEAL FOR THE
BACKSIDE OF PCBS WHEN SPACE AND
HEIGHT IS A PREMIUM
FOR THE DESIRED V
OUT
February 26, 2010
FN6727.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2009, 2010. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.