IS61NLP12832A
IS61NLP12836A/IS61NVP12836A
IS61NLP25618A/IS61NVP25618A
128K x 32, 128K x 36, and 256K x 18
4Mb, PIPELINE 'NO WAIT' STATE BUS SRAM
®
ISSI
PRELIMINARYINFORMATION
SEPTEMBER 2005
FEATURES
DESCRIPTION
The 4 Meg 'NLP/NVP' product family feature high-speed,
low-power synchronous static RAMs designed to provide
a burstable, high-performance, 'no wait' state, device for
networking and communications applications. They are
organizedas128Kwordsby32bits,128Kwordsby36bits,
and256K wordsby18bits,fabricatedwithISSI'sadvanced
CMOS technology.
• 100 percent bus utilization
• No wait cycles between Read and Write
• Internal self-timed write cycle
• Individual Byte Write Control
• Single R/W (Read/Write) control pin
• Clock controlled, registered address,
data and control
Incorporating a 'no wait' state feature, wait cycles are
eliminated when the bus switches from read to write, or
write to read. This device integrates a 2-bit burst counter,
high-speed SRAM core, and high-drive capability outputs
into a single monolithic circuit.
• Interleaved or linear burst sequence control using
MODE input
• Three chip enables for simple depth expansion
and address pipelining
Allsynchronousinputspassthroughregistersarecontrolled
byapositive-edge-triggeredsingleclockinput.Operations
may be suspended and all synchronous inputs ignored
when Clock Enable, CKE is HIGH. In this state the internal
device will hold their previous values.
• Power Down mode
• Common data inputs and data outputs
• CKE pin to enable clock and suspend operation
All Read, Write and Deselect cycles are initiated by the
ADV input. When the ADV is HIGH the internal burst
counter is incremented. New external addresses can be
loaded when ADV is LOW.
• JEDEC 100-pin TQFP, 165-ball PBGA and 119-
ball PBGA packages
• Power supply:
Write cycles are internally self-timed and are initiated by
the rising edge of the clock inputs and when WE is LOW.
Separate byte enables allow individual bytes to be written.
NVP: VDD 2.5V (± 5%), VDDQ 2.5V (± 5%)
NLP: VDD 3.3V (± 5%), VDDQ 3.3V/2.5V (± 5%)
• Industrial temperature available
• Lead-free available
A burst mode pin (MODE) defines the order of the burst
sequence.WhentiedHIGH,theinterleavedburstsequence
is selected. When tied LOW, the linear burst sequence is
selected.
FAST ACCESS TIME
Symbol
tKQ
Parameter
-250
2.6
4
-200
3.1
5
Units
ns
Clock Access Time
Cycle Time
tKC
ns
Frequency
250
200
MHz
Copyright © 2005 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without notice. ISSI assumes no liability
arisingoutoftheapplicationoruseofanyinformation, productsorservicesdescribedherein. Customersareadvisedtoobtainthelatestversionofthisdevicespecificationbeforerelyingonany
publishedinformationandbeforeplacingordersforproducts.
Integrated Silicon Solution, Inc. — www.issi.com — 1-800-379-4774
Rev. 00C
1
09/12/05