5秒后页面跳转
HV862 PDF预览

HV862

更新时间: 2024-11-04 03:43:11
品牌 Logo 应用领域
超科 - SUPERTEX 驱动器
页数 文件大小 规格书
7页 694K
描述
Dimmable, Low Noise, Dual EL Lamp Driver

HV862 数据手册

 浏览型号HV862的Datasheet PDF文件第2页浏览型号HV862的Datasheet PDF文件第3页浏览型号HV862的Datasheet PDF文件第4页浏览型号HV862的Datasheet PDF文件第5页浏览型号HV862的Datasheet PDF文件第6页浏览型号HV862的Datasheet PDF文件第7页 
HV862  
Dimmable, Low Noise, Dual EL Lamp Driver  
The device uses a single inductor and a minimum number of  
passive components. Using the internal reference voltage,  
the regulated output voltage is at a nominal value of 90V.  
The EL Lamps will therefore see 90V. The two EL Lamps  
can be turned ON and OFF using two CMOS logic inputs,  
EN1 and EN2. The driver is disabled when both EN1 and  
EN2 are at logic low.  
Features  
Adjustable output regulation for dimming  
Lamp fade-in/fade-out capability  
Low audible noise  
180VPP output voltage for higher brightness  
1.5V enable input logic high  
Single cell lithium ion compatible  
One miniature inductor to power both lamps  
Separately adjustable lamp and converter frequencies  
Split supply capability  
The HV862 has two internal oscillators, a switching MOSFET,  
and two high voltage EL Lamp driver H-bridges. Each driver  
has its own half bridge common output, COM1 and COM2,  
which significantly minimizes the DC offset seen by the EL  
Lamp. The frequency for the switching MOSFET is set by an  
external resistor connected between the RSW-osc pin and the  
supply pin VDD. The EL Lamp driver frequency is set by an  
16-Lead QFN package  
Applications  
Dual display cellular phones  
Keypad and LCD backlighting  
PDAs  
Handheld wireless communication products  
Global Positioning Systems (GPS)  
external resistor connected between the R  
pin and the  
VDD pin. An external inductor is connectedELb-oestcween the LX  
and VDD pins or VIN for split supply applications. Depending  
upon the EL Lamp sizes, a 1.0nF to 10.0nF capacitor is  
connected between the CS and ground.  
As the switching MOSFET charges the external inductor  
and discharges it into the capacitor at C , the voltage at  
CS will start to increase. Once the voltageSat C reaches a  
nominal value of 90V, the switching MOSFET isSturned OFF  
to conserve power.  
General Description  
The Supertex HV862 is a low noise, dimmable, high  
voltage, dual EL Lamp driver designed for driving two  
electroluminescent (EL) Lamps with a combined area of 5.0  
square inches. The input supply voltage range is from 2.5V  
to 4.5V. Enable input logic high can go as low as 1.5V, which  
allows logic interface operating from typical 1.8V supplies.  
The device is designed to minimize audible noise emitted by  
the EL Lamps.  
EL Lamp dimming can be accomplished by applying a PWM  
logic signal to the PWM pin. The EL Lamp brightness will be  
proportional to the PWM duty cycle. The HV862 can also  
slowly turn the EL Lamp ON/OFF giving a fade ON/OFF  
appearance.  
Typical Application Circuit  
VIN = 3.2V to 4.2V  
100µH Coilcraft  
1N4148  
4.7µF  
LPS4012  
3.3MΩ  
3.3nF  
100V NPO  
15  
14  
7
8
VREG VOUT LX  
CS  
12  
3
1
2
EL1  
VDD  
V
DD = 3.0V  
2.0MΩ  
EL1  
EL2  
REL-osc  
RSW-osc  
11  
9
0.1µF  
COM1  
EL2  
825kΩ  
Input Logic Control:  
ON = 1.5V to VDD  
OFF = 0V to 0.2V  
4
5
EN1  
EN2  
10  
COM2  
PWM GND  
VREF  
16  
13  
6
2.2µF  
HV862K7-G  

与HV862相关器件

型号 品牌 获取价格 描述 数据表
HV862K7-G SUPERTEX

获取价格

Dimmable, Low Noise, Dual EL Lamp Driver
HV8708DJ ETC

获取价格

Interface IC
HV8708PJ ETC

获取价格

Interface IC
HV8708X ETC

获取价格

Interface IC
HV87SM-42 SPECTRUM

获取价格

Voltage Controlled Oscillator
HV87T-4 SPECTRUM

获取价格

Voltage Controlled Oscillator
HV8808DJ ETC

获取价格

Interface IC
HV8808PJ ETC

获取价格

Interface IC
HV8808X ETC

获取价格

Interface IC
HV881 SUPERTEX

获取价格

Dimmable, Low Noise, 16 channel EL Lamp Driver