Supertex inc.
HV881
Dimmable, Low Noise, 16 channel
EL Lamp Driver
Features
The HV881 has two internal oscillators and a high voltage
EL lamp driver. An external MOSFET is driven by the switch
oscillator to generate output voltage.
► Sixteen channel EL lamp driver with single common
terminal
► 1nF maximum load on each of the sixteen channels
► Independent dimming capability for all lamps
► Sixteen brightness levels for each lamp
► 1.8 to 5.5V operating supply range
► 1.7V logic interface
The frequency for the external switching MOSFET is set
by an external resistor connected between the RSW-Osc
pin and the VDD supply pin. The EL lamp driver frequency
can be set by either an external logic signal frequency at
the SEL pin or by an external resistor connected between
the REL-Osc pin and VDD pin. If external frequency is input
at the SEL pin, the REL-Osc pin should be connected to
ground.
► Dedicated enable logic pin
► 340VP-P nominal output voltage for high brightness
► Low audible noise
► Output voltage regulation
► EL1 - EL16 outputs fall time control
► Two EL frequency controls
An external inductor is connected between the LX and VDD
or VIN pins for split supply applications. Depending upon
the EL lamp sizes, a 1.0 to 10.0nF capacitor is connected
between the CS pin and ground. The CS capacitor is
connected to the internal H-bridge, and the energy stored
in the capacitor is therefore transferred to the EL lamp.
One side of all the sixteen EL lamps is connected to the
respective EL pins (EL1, EL2, etc.), and the other side is
connected to the COM pin.
► External switching MOSFET
► I2C data communication control
► Single lithium-ion cell compatible
► One miniature inductor to power sixteen lamps
► Independent lamp and converter frequency setting
► Split supply capability
► 5x5mm, 32-Lead QFN package
Applications
The external switching MOSFET charges the inductor and
discharges it into the capacitor at CS. The voltage at CS
will start to increase. Once the voltage at CS reaches the
desired regulation limit, the external switching MOSFET is
turned off to conserve power.
► Multi-segment, variable displays
► Cell phone keypads and displays
► Multi-segment remote controls
► Handheld wireless communication products
► Global Positioning Systems (GPS)
The HV881 allows for controlling the fall time of the EL1
- EL16 outputs by an external resistor from the RSLOPE
pin to the VDD pin. This feature can be used to reduce
the audible noise of the EL lamp or to increase the lamp
brightness.
General Description
The Supertex HV881 is a 16 channel EL lamp driver with a
single common terminal. It can drive up to a 1nF ELlamp load
(approx. 0.3in2 lamp size) on each of the sixteen channels.
The input supply voltage range is 1.8 to 5.5V. The logic
interface to the device can be as low as 1.7V. The device
has an enable logic input pin to turn the device on or off.
The brightness of each of the sixteen EL lamps can be
independently controlled to have one of fifteen brightness
levels or can be completely turned off by the serial data
(SDA) input. The serial data input has a 4-bit binary code
for each lamp, to control the brightness level from level 0
to level 15. The brightness is controlled by controlling the
number of EL frequency cycles (from 0 to 15) in a group of
15 cycles.
The device is designed to minimize audible noise emitted by
the EL lamp. The HV881 uses an external MOSFET, a single
inductor and minimum number of passive components to
drive all sixteen EL lamps. The device is designed such that
the input voltage to the inductor can be different from the
input voltage to the device (split supply).
Supertex inc. ● 1235 Bordeaux Drive, Sunnyvale, CA 94089 ● Tel: 408-222-8888 ● www.supertex.com
5秒后页面跳转
LTM4644/LTM4644-1：创新的四输出同步降压微模块调节器
2N3500：一款多用途NPN硅晶体管的全面解析
最详细资料解析：BA5917AFP参数说明、引脚说明
MAX232IDR数据手册：产品特性、电气参数、替代型号推荐
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
