5秒后页面跳转
HV857X PDF预览

HV857X

更新时间: 2024-11-24 22:48:27
品牌 Logo 应用领域
超科 - SUPERTEX 驱动器高压
页数 文件大小 规格书
14页 638K
描述
High Voltage EL Lamp Driver for Low Noise Applications

HV857X 数据手册

 浏览型号HV857X的Datasheet PDF文件第2页浏览型号HV857X的Datasheet PDF文件第3页浏览型号HV857X的Datasheet PDF文件第4页浏览型号HV857X的Datasheet PDF文件第5页浏览型号HV857X的Datasheet PDF文件第6页浏览型号HV857X的Datasheet PDF文件第7页 
HV857  
High Voltage EL Lamp Driver for  
Low Noise Applications  
Features  
General Description  
Patent pending audible noise reduction  
Patent pending lamp aging compensation  
190VPP output voltage for higher brightness  
Patented output timing for high efficiency  
Single cell lithium ion compatible  
150nA shutdown current  
The Supertex HV857 is a high voltage driver designed for driving  
Electroluminescent (EL) lamps of up to 5 square inches. The  
input supply voltage range is from 1.8V to 5.0V. The device uses  
asingleinductorandaminimumnumberofpassivecomponents.  
The nominal regulated output voltage that is applied to the EL  
lamp is ±95V. The chip can be enabled/disabled by connecting  
the resistor on Rsw-osc to VDD/ground.  
The HV857 has two internal oscillators, a switching MOSFET,  
and a high voltage EL lamp driver. The frequency for the  
switching MOSFET is set by an external resistor connected  
between the Rsw-osc pin and the supply pin VDD. The EL lamp  
driver frequency is set by an external resistor connected be-  
tween REL-osc pin and the VDD pin. An external inductor is  
connected between the LX and VDD pins or VIN for split supply  
applications. A 0.003-0.1µF capacitor is connected between Cs  
and ground. The EL lamp is connected between VA and VB.  
Wide input voltage range 1.8V to 5.0V  
Separately adjustable lamp and converter frequencies  
Output voltage regulation  
Split supply capability  
Applications  
LCD backlighting  
Mobile cellular phones  
PDAs  
The switching MOSFET charges the external inductor and  
discharges it into the capacitor at Cs. The voltage at Cs will start  
to increase. Once the voltage at Cs reaches a nominal value of  
95V, the switching MOSFET is turned OFF to conserve power.  
The outputs VA and VB are configured as an H bridge and are  
switchinginoppositestatestoachieve ±95VacrosstheELlamp.  
Handheld wireless communication products  
Global Positioning Systems (GPS)  
Typical Application  
Enable Signal  
ON=VDD  
OFF=0  
Regulated Voltage=VDD  
VDD  
1
VA  
8
EL Lamp  
RSW-osc  
VB  
CS  
LX  
7
6
5
2
3
4
+
REL-osc  
Gnd  
V
=VIN  
DD  
CIN  
LX  
HV857MG  
CS  
11/14/01  
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability  
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to  
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the  
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.  

与HV857X相关器件

型号 品牌 获取价格 描述 数据表
HV858 SUPERTEX

获取价格

Tri-EL Lamp Driver IC
HV858K7-G SUPERTEX

获取价格

Tri-EL Lamp Driver IC
HV858MG SUPERTEX

获取价格

Tri-EL Lamp Driver IC
HV858MG-G SUPERTEX

获取价格

Tri-EL Lamp Driver IC
HV858X SUPERTEX

获取价格

EL Driver, 1-Segment, DIE
HV859 SUPERTEX

获取价格

High Voltage EL Lamp Driver for Low Noise Applications
HV859 MICROCHIP

获取价格

HV859 is a high voltage driver designed for driving Electroluminescent (EL) lamps of up to
HV859K7-G SUPERTEX

获取价格

High Voltage EL Lamp Driver for Low Noise Applications
HV859MG-G SUPERTEX

获取价格

High Voltage EL Lamp Driver for Low Noise Applications
HV860 SUPERTEX

获取价格

Low Noise Dimmable EL Lamp Driver