Heatshrink
Adhesive Lined
Description:
This is a flexible, flame retarded heat-shrinkable polyolefin tubing, with
a shrink ratio of 4 : 1 with a thick wall adhesive which melts and flows,
to seal components contained within. Recommended for applications
requiring water-proofing for light cable and wire harnesses and protection
of connector components.
Features :
•
•
•
•
•
EPA method 3050B
BSEN1122
: 1996 other acid digestion
: 2001 method B other acid digestion
: 1996 other acid digestion
: 1992
EPA method 3052B
EPA method 3060 and EPA 7196A
Atomic absorption spectrometer / inductively coupled plasma atomic emission spectrometer (ICP + AES) UV-VIS
spectrophotometer
Characteristics:
Operating Temperature
Minimum Shrink Temperature
Shrink Ratio
: -55°C to +125°C
: 70°C
: 3:1 and 4:1
: Black
Standard Colour
(Other colours are also available on request)
Applications:
Manufactured by co-extrusion of polyolefin and hot-melt adhesive. Designed to provide both insulation and sealing for the
protected items. Typically uses are the protection of automotive wires, bundled wires and metal tubes against water and
moisture. The high expansion ratio makes it possible to repair most damaged cable jackets without removing connectors.
Technical Data:
Property
Tensile Strength
Test Method
Typical Data
10.4Mpa
30
ASTM D 2671
Ultimate Elongation (%)
Longitudinal Shrinkage (%)
UL 224
0 to -10
Heat Aging
Ultimate Elongation (%)
158°, 168hr
200
Flammability
VW-1
Pass (outer jacket only)
Dielectric Strength (kv / mm)
Volume Resistivity (ohm-cm)
Copper Stability
IEC 243
UL224
20
1 × 1014
Pass
ASTM D 2671
UL224
Corrosion
No corrosion
www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
Page <1>
01/03/13 V1.0