12/00
0.1 TO 6.0 GHz
ANALOG DETECTOR
DAQ6103
Typical Values @ +25° C
DAQ6103
DAQ6103
Wide Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.1 to 8.0 GHz
Wide Power Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . –10.0 to 25.0 dBm
Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Single or Dual Power Supply
± 0.25 dB
± 0.5 dB
1.2:1
1/4 Inch SMTO-8 for Detectors
0.010
4 PI
Cougar Q Package
SPECIFICATIONS
Guaranteed*
0.230
Parameter
Typical
0 to 50° C
-55 to +85° C
0.100
0.055, 4 PL
0.010 R. 4 PL
Frequency (Min.)
0.1-8.0 GHz
0.1-6.0 GHz
0.1-6.0 GHz
FULL R.
TYP.
0.030
3 PL
Input Power Range (Min.)
VSWR (Max.)
-10 to 25 dBm
1.2:1†
-5 to 20 dBm
1.5:1†
-5 to 20 dBm
1.5:1†
0.250
SQ
0.230
Sensitivity, Vout (Min.)
Power Flatness (Max.)
Temperature Stability (Max.)
120 mV†
±0.5 dB^
90 mV†
90 mV†
0.016
0.014
4 PL
±0.75 dB^
±0.5 dB†
±0.75 dB^
±0.5 dB†
0.040
0.040 4 PL
±0.015
0.015
8 PL
±0.25 dB†
±0.001
0.008
Output Offset Voltage,
no RF (Max.)
0.025
4 PL
±0.5 mV
+10 dBm
±2.0 mV
±2.0 mV
0.040
4 PL
0.025
1 dB Square Law Departure
Tangential Sensitivity
—
—
—
—
—
—
—
—
—
—
—
—
-25 dBm^^
1.5 µsec‡
Pulse Response, Pin = +5 dBm
Pulse Response, Pin = +25 dBm
Max Output Voltage
3.0 µsec‡
Vs-1 Volts
Supply Current, no RF
2 +mA, 2 -mA
10 +mA, 2 -mA
DAS6103
Supply Current, Pin = +25 dBm
SMTO-8 Package for Detectors
* Measured in a 50-ohm system at ±5 Vdc, 2 KΩ||50 pF unless otherwise specified.
† Pin = +5 dBm. ^ Vout = 100 mV. ^^ 3 dB NF, 1 MHz Bandwidth. ‡ 50% RF to 10 or 90% Video.
DETAIL A
(NO SCALE)
0.016 ± 0.002
0.010 ± 0.002
DC BIAS
MAXIMUM RATINGS
0
DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
±18 V
0.016 ± 0.002
(0.41 ± 0.05)
(4) PLCS
50 Ω INPUT
Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . +27 dBm (±5 Vdc)
Operating Case Temperature . . . . . . . . . . . . . . . . . . . -55° C to +100° C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . -65° C to +125° C
0.008
0.012
0.250
(6.35)
50 Ω OUTPUT
0.450
Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . .
Detector Thermal Resistance1 (θjc) . . . . . . . . . . . . . . .
Temperature Rise @ +20 dBm (Tjc) . . . . . . . . . . . . . .
100° C
3500° C/Watt
3.5° C
(11.43)
0.040 ± 0.012
(1.02 ± 0.30)
(4) PLCS
GND
SEE
DETAIL "A"
0.170
(4.32)
0.050
(1.27)
1 Thermal resistance is based on total power dissipation. Ratings based on +25° C.
(4) PLCS
0
0.100
(2.54)
(4) PLCS
0.075
(1.91)
0.200
(5.08)
APPLICATIONS
0.350
(8.89)
0.450
0.031
(0.79)
0.031
(0.79)
This unit is DC coupled and employs a RF choke at the input (DC short). If the application
calls for the input to sink current there will approximately be an additional 1 mV of output
offset voltage for each 3 mA of current. Sink current should be limited to 100 mA max to
avoid choke burnout.
(11.43)
0.010
(0.25)
0.008 ± 0.001
(0.20 ± 0.03)
(TYP.)
45°
For higher supply voltages, up to ±15 volts, the positive supply pin must include a series
current limiting resistor, Rs = (Vs – 5)/0.01. (e.g.: Vs = 15v, Rs = 1K)
Average power detection is obtained at power levels below approximately
+7 dBm.
For best pulse response the supply pins should be bypassed with an additional
0.1 µF capacitor. The unit contains 0.01 µF internal capacitors.
394
408-522-3838 • Fax 408-522-3839 • www.cougarcorp.com
2001