5秒后页面跳转
CY8CLEDAC02 PDF预览

CY8CLEDAC02

更新时间: 2024-11-25 12:52:43
品牌 Logo 应用领域
赛普拉斯 - CYPRESS 控制器
页数 文件大小 规格书
20页 1646K
描述
AC-DC Controller for Dimmable LED Lighting

CY8CLEDAC02 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:SOIC包装说明:HSOP,
针数:8Reach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.39.00.01
风险等级:5.81其他特性:ALSO OPERATES AS LDO REGULATOR, ALSO HAS CONTROL TECHNIQUE OF RESONANT
模拟集成电路 - 其他类型:SWITCHING CONTROLLER控制技术:PULSE WIDTH MODULATION
最大输入电压:1.8 V最小输入电压:
JESD-30 代码:R-PDSO-G8长度:4.902 mm
功能数量:1端子数量:8
最高工作温度:85 °C最低工作温度:-40 °C
最大输出电流:0.0045 A封装主体材料:PLASTIC/EPOXY
封装代码:HSOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE认证状态:Not Qualified
座面最大高度:1.702 mm表面贴装:YES
切换器配置:SINGLE最大切换频率:200 kHz
技术:CMOS温度等级:INDUSTRIAL
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL宽度:3.89 mm
Base Number Matches:1

CY8CLEDAC02 数据手册

 浏览型号CY8CLEDAC02的Datasheet PDF文件第2页浏览型号CY8CLEDAC02的Datasheet PDF文件第3页浏览型号CY8CLEDAC02的Datasheet PDF文件第4页浏览型号CY8CLEDAC02的Datasheet PDF文件第5页浏览型号CY8CLEDAC02的Datasheet PDF文件第6页浏览型号CY8CLEDAC02的Datasheet PDF文件第7页 
CY8CLEDAC02  
AC-DC Controller for Dimmable  
LED Lighting  
Features  
Description  
AC offline input range from 80 to 277 VAC  
Up to 25 W output power range  
The CY8CLEDAC02 is a high performance offline LED driver,  
designed to interface directly with most conventional phase cut  
based wall dimmers. The device uses proprietary digital control  
technology to provide automatic detection of dimmer type  
(leading or trailing edge). It automatically generates dimming  
signals for LED loads and has the ability to dim down to 2  
percent. It modulates LED brightness using a linear dimming  
scheme and switches to a pulse width modulation (PWM) based  
dimming scheme for output current levels lower than 20 percent  
of the full load current. In PWM mode optimized dimming  
frequencies in the range of 900 Hz result in zero visible flicker.  
Intelligent wall dimmer detection:  
Leading edge (R, RL) dimmers  
Trailing edge (RC, RLC) dimmers  
No dimmer  
Wide dimming range from 2 to 100 percent  
Resonant control to achieve high efficiency  
(85 percent without dimmer)  
At the heart of a CY8CLEDAC02 based system is the chopping  
circuit which provides the load necessary to enable correct wall  
dimmer operation. It also improves PF when there is no dimmer  
on the line.  
Meets harmonic requirement with high power factor  
(0.7 without dimmer)  
Primary-side sensing eliminates opto-isolators  
Tight LED current regulation (typically < + 2.5 percent)  
Low startup current (typically 10A)  
The devices’ proprietary primary side sensing enables tight LED  
current regulation and eliminates the need for secondary  
feedback circuitry. No opto-couplers are necessary to meet UL  
isolation requirements; enabling flyback conversion with  
automatic isolation.  
Low startup time (typically 0.5 s with active startup)  
The CY8CLEDAC02 operates in quasi-resonant mode to  
achieve high efficiency. This mode of operation helps minimize  
external component count and simplifies EMI design, lowering  
the total bill of material cost.  
Multiple protection features:  
Output overvoltage protection (OOVP)  
Output short circuit protection (OSCP)  
Overtemperature protection (OTP)  
Current-sense resistor short protection (CSSP)  
Peak current limit protection (PCLP)  
Single-point fault protection  
The device’s cycle-by-cycle adaptive digital regulation uses  
critical discontinuous conduction mode (CDCM) when driving  
LED loads. The control algorithm for cycle-by-cycle regulation  
has internal compensation for guaranteed system phase and  
gain margins; requiring no external components for loop  
compensation.  
Applications:  
Dimmable offline LED driver  
Dimmable LED replacement lamps  
Dimmable LED luminaires  
The CY8CLEDAC02 has full featured circuit protection not  
normally available with other primary-side control solutions. The  
built-in protection includes output overvoltage protection, output  
short  
circuit  
protection,  
overtemperature  
protection,  
current-sense resistor short protection, and peak current limit  
protection. It also enables automatic LED brightness adjustment  
to compensate for temperature drift by simply connecting a NTC  
resistor to the VT pin.  
Cypress Semiconductor Corporation  
Document Number: 001-54879 Rev. *C  
198 Champion Court  
San Jose, CA 95134-1709  
408-943-2600  
Revised October 26, 2010  
[+] Feedback  

CY8CLEDAC02 替代型号

型号 品牌 替代类型 描述 数据表
A80601KESJSR-1 ALLEGRO

功能相似

High Power LED Driver with Pre-Emptive Boost for Ultra-High Dimming Ratio and Low Output R

与CY8CLEDAC02相关器件

型号 品牌 获取价格 描述 数据表
CY8CLEDAC03H CYPRESS

获取价格

LED Driver, 2-Segment, CMOS, PDSO8, MS-012F, SOIC-8
CY8CLEDAC03L CYPRESS

获取价格

LED Driver, 2-Segment, CMOS, PDSO8, MS-012F, SOIC-8
CY8CMBR2010_12 CYPRESS

获取价格

CapSense® Express™ 10-Button Controller
CY8CMBR2010-24LQXI CYPRESS

获取价格

CapSense® Express™ 10-Button Controller
CY8CMBR2010-24LQXIT CYPRESS

获取价格

CapSense® Express™ 10-Button Controller
CY8CMBR2016 CYPRESS

获取价格

CapSense® Express™ 16 Button Matrix Contro
CY8CMBR2016-24LQXI CYPRESS

获取价格

CapSense® Express™ 16 Button Matrix Contro
CY8CMBR2016-24LQXI INFINEON

获取价格

CY8CMBR2016
CY8CMBR2016-24LQXIT CYPRESS

获取价格

CapSense® Express™ 16 Button Matrix Contro
CY8CMBR2016-24LQXIT INFINEON

获取价格

CY8CMBR2016