5秒后页面跳转
捷配首页

Datasheet > ATSAM4SA16CA-AU
ATSAM4SA16CA-AU PDF预览

ATSAM4SA16CA-AU

更新时间： 2024-11-25 12:23:43
品牌 Logo 应用领域
爱特美尔 - ATMEL 闪存微控制器外围集成电路时钟
页数 文件大小 规格书
67页 638K
描述
ARM-based Flash MCU

阅读下载

中文翻译

获取价格

ATSAM4SA16CA-AU 数据手册

 浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第2页浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第3页浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第4页浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第5页浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第6页浏览型号ATSAM4SA16CA-AU的Datasheet PDF文件第7页 
Features  
• Core  
– ARM® Cortex®-M4 with a 2Kbytes cache running at up to 120 MHz  
– Memory Protection Unit (MPU)  
– DSP Instruction Set  
– Thumb®-2 instruction set  
• Pin-to-pin compatible with SAM3N, SAM3S products (64- and 100- pin versions) and  
SAM7S legacy products (64-pin version)  
• Memories  
– Up to 2048 Kbytes embedded Flash with optional dual bank and cache memory  
– Up to 160 Kbytes embedded SRAM  
– 16 Kbytes ROM with embedded boot loader routines (UART, USB) and IAP routines  
– 8-bit Static Memory Controller (SMC): SRAM, PSRAM, NOR and NAND Flash support  
• System  
AT91SAM  
ARM-based  
Flash MCU  
– Embedded voltage regulator for single supply operation  
– Power-on-Reset (POR), Brown-out Detector (BOD) and Watchdog for safe operation  
– Quartz or ceramic resonator oscillators: 3 to 20 MHz main power with Failure  
Detection and optional low-power 32.768 kHz for RTC or device clock  
– RTC with Gregorian and Persian Calendar mode, waveform generation in low-  
power modes  
– RTC clock calibration circuitry for 32.768 kHz crystal frequency compensation  
– High precision 8/12 MHz factory trimmed internal RC oscillator with 4 MHz default  
frequency for device startup. In-application trimming access for frequency  
adjustment  
SAM4S Series  
– Slow Clock Internal RC oscillator as permanent low-power mode device clock  
– Two PLLs up to 240 MHz for device clock and for USB  
– Temperature Sensor  
– Up to 22 Peripheral DMA (PDC) Channels  
• Low Power Modes  
Preliminary  
Summary  
– Sleep and Backup Modes, down to 1 µA in Backup Mode  
– Ultra low-power RTC  
• Peripherals  
– USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints. On-Chip  
Transceiver  
– Up to 2 USARTs with ISO7816, IrDA®, RS-485, SPI, Manchester and Modem Mode  
– Two 2-wire UARTs  
– Up to 2 Two Wire Interface (I2C compatible), 1 SPI, 1 Serial Synchronous Controller  
(I2S), 1 High Speed Multimedia Card Interface (SDIO/SD Card/MMC)  
– 2 Three-Channel 16-bit Timer/Counter with capture, waveform, compare and PWM  
mode. Quadrature Decoder Logic and 2-bit Gray Up/Down Counter for Stepper  
Motor  
– 4-channel 16-bit PWM with Complementary Output, Fault Input, 12-bit Dead Time  
Generator Counter for Motor Control  
– 32-bit Real-time Timer and RTC with calendar and alarm features  
– Up to 16-channel, 1Msps ADC with differential input mode and programmable gain  
stage and auto calibration  
– One 2-channel 12-bit 1Msps DAC  
– One Analog Comparator with flexible input selection, Selectable input hysteresis  
– 32-bit Cyclic Redundancy Check Calculation Unit (CRCCU)  
– Write Protected Registers  
• I/O  
– Up to 79 I/O lines with external interrupt capability (edge or level sensitivity),  
debouncing, glitch filtering and on-die Series Resistor Termination  
– Three 32-bit Parallel Input/Output Controllers, Peripheral DMA assisted Parallel  
Capture Mode  
NOTE: This is a summary document.  
The complete document is currently not  
available. For more information, please  
contact your local Atmel sales office.  
• Packages  
– 100-lead LQFP, 14 x 14 mm, pitch 0.5 mm/ 100-ball TFBGA, 9 x 9 mm, pitch 0.8 mm/  
100-ball VFBGA, 7 x 7 mm, pitch 0.65 mm  
– 64-lead LQFP, 10 x 10 mm, pitch 0.5 mm/ 64-pad QFN 9x9 mm, pitch 0.5 mm  
11100BS–ATARM–31-Jul-12  
1234567...67

中文翻译

下载PDF

与ATSAM4SA16CA-AU相关器件

型号 品牌 获取价格 描述 数据表
ATSAM4SA16CA-CFU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SA16CA-CU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD16B MICROCHIP

获取价格

 		For New Designs, we highly recommend to consider Revision B for Prototypes and Production.
ATSAM4SD16BA-AU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD16BA-MU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD16C MICROCHIP

获取价格

 		For New Designs, we highly recommend to consider Revision B for Prototypes and Production.
ATSAM4SD16CA-AU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD16CA-CFU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD16CA-CU ATMEL

获取价格

 		ARM-based Flash MCU
ATSAM4SD32B MICROCHIP

获取价格

 		For New Designs, we highly recommend to consider Revision B for Prototypes and Production.

与ATSAM4SA16CA-AU相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证