austriamicrosystems
Data Sheet
AS1152
Quad LVDS Driver
1 General Description
2 Key Features
!
The AS1152 is a Quad Flow-Through LVDS (Low-Volt-
age Differential Signaling) Line Driver which accepts
and converts LVTTL/LVCMOS input levels into LVDS
output signals. The device is perfect for low-power low-
noise applications requiring high signaling rates and
reduced EMI emissions.
Flow-Through Pinout
!
Guaranteed 500Mbps Data Rate (paired with
AS1150)
!
!
!
!
!
350ps Pulse Skew (Max)
Conforms to ANSI TIA/EIA-644 LVDS Standards
Single +3.3V Supply
The device is guaranteed to transmit data at speeds up
to 500Mbps (250MHz) over controlled impedance media
of approximately 100Ω. Supported transmission media
are PCB traces, backplanes, and cables.
Operating Temperature Range: -40 to +85°C
16-Pin TSSOP Package
The AS1152 is capable of setting all four outputs to a
high-impedance state through two Enable Inputs (EN
and ENn – internally pulled down to GND), dropping the
device to an ultra-low-power state of 16mW (typical) dur-
ing high impedance. The Enable Inputs are common to
all four drivers.
3 Applications
Digital Copiers, Laser Printers, Cellular Phone Base Sta-
tions, Add/Drop Muxes, Digital Cross-Connects,
DSLAMs, Network Switches/Routers, Backplane Inter-
connect, Clock Distribution Computers, Intelligent Instru-
ments, Controllers, Critical Microprocessors and
Microcontrollers, Power Monitoring, and Portable/Bat-
tery-Powered Equipment.
Outputs conform to the ANSI TIA/EIA-644 LVDS stan-
dards. Flow-through pinout simplifies PC board layout
and reduces crosstalk by separating the LVTTL/LVC-
MOS inputs and LVDS outputs.
The AS1152 operates from a single +3.3V supply and is
specified for operation from -40 to +85°C.
Figure 1. Block Diagram
VCC
OUT1+
OUT1-
IN1
IN2
IN3
OUT2+
OUT2-
OUT3+
OUT3-
OUT4+
OUT4-
IN4
EN
ENn
AS1152
www.austriamicrosystems.com
Revision 1.00
1 - 15