16-Bit, Isolated,
Sigma-Delta Modulator
ADuM7702
Data Sheet
FEATURES
FUNCTIONAL BLOCK DIAGRAM
V
V
DD2
DD1
5 MHz to 21 MHz master clock input frequency
Offset drift vs. temperature: 0.25 µV/°C
SNR: 82 dB typical
ADuM7702
CLK
DECODER
CLK
ENCODER
MCLKIN
MDAT
16 bits, no missing codes
Full-scale analog input voltage range: 64 mV
ENOB: 13 bits typical
V
V
IN+
DATA
ENCODER
DATA
DECODER
GAIN
I
DD1: 10 mA maximum
Σ-Δ ADC
IN–
On-board digital isolator
Operating temperature range: −40°C to +125°C
High isolation common-mode transient immunity:
150 kV/µs minimum, VDD2 = 3.3 V
Wide-body SOICs
GND
GND
2
1
Figure 1.
16-lead SOIC_W
8-lead SOIC_IC with increased creepage
Safety and regulatory approvals
UL recognition
5700 V rms for 1 minute per UL 1577
CSA Component Acceptance Notice 5A
VDE Certificate of Conformity
DIN V VDE V 0884-10: VIORM = 1270 VPEAK
DIN V VDE V 0884-11: VIORM = 1060 VPEAK (pending)
APPLICATIONS
Shunt current monitoring
AC motor controls
Power and solar inverters
Wind turbine inverters
Analog-to-digital and optoisolator replacement
GENERAL DESCRIPTION
The ADuM7702 is a high performance, second-order, Σ-Δ
modulator that converts an analog input signal to a high speed,
single-bit data stream, with on-chip digital isolation based on
Analog Devices, Inc., iCoupler® technology. The device operates
from a 4.5 V to 5.5 V power supply range (VDD1) and accepts a
pseudo differential input signal of 50 mV ( 64 mV full-scale).
The pseudo differential input is ideally suited to shunt voltage
monitoring in high voltage applications where galvanic isolation
is required.
The analog input is continuously sampled by a high performance
analog modulator and converted to a ones density digital output
stream with a data rate of up to 21 MHz. The original information
can be reconstructed with an appropriate sinc3 digital filter to
achieve an 82 dB signal-to-noise ratio (SNR) at 78.1 kSPS with a
256 decimation rate and a 20 MHz master clock. The serial input
and output operates from a 5 V or a 3 V supply (VDD2).
The serial interface is digitally isolated. High speed complementary
metal-oxide semiconductor (CMOS) technology, combined with
monolithic transformer technology, results in on-chip isolation
providing outstanding performance characteristics, superior to
alternatives such as optocoupler devices. The ADuM7702 is
available in both a 16-lead SOIC_W and an 8-lead SOIC_IC
and has an operating temperature range of −40°C to +125°C.
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks are theproperty of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2020 Analog Devices, Inc. All rights reserved.
www.analog.com