16-Bit, Isolated,
Sigma-Delta ADC
ADuM7703
Data Sheet
FEATURES
FUN°TIONAL BLO°K DIAGRAM
V
V
DD2
DD1
5 MHz to 21 MHz master clock input frequency
Offset drift vs. temperature: 0.6 ꢀμV/° maximum
SNR: 86 dB typical
16 bits, no missing codes
Full-scale analog input voltage range: 320 mμ
ENOB: 14 bits typical
ADuM7703
CLK
CLK
MCLKIN
MDAT
DECODER
ENCODER
V
IN+
DATA
ENCODER
DATA
DECODER
I
DD1: 10 mA maximum
GAIN
GND
Σ-∆ ADC
V
IN–
On-board digital isolator
Operating temperature range
−40/° to +125/° (16-lead SOI°_W)
−40/° to +105/° (8-lead SOI°_I°)
20 μ operation on μDD1
GND
1
2
Figure 1.
High °MTI: 150 kμVꢀs minimum, μDD2 = 3.3 μ
Wide-body SOI°s
16-lead SOI°_W
8-lead SOI°_I° with increased creepage
Safety and regulatory approvals
UL recognition
5700 μ rms for 1 minute per UL 1577
°SA °omponent Acceptance Notice 5A (Pending)
μDE °ertificate of °onformity
DIN μ μDE μ 0884-10: μIORM = 1270 μPEAK
DIN μ μDE μ 0884-11: μIORM = 1060 μPEAK (Pending)
APPLI°ATIONS
Shunt current monitoring
A° motor controls
Power and solar inverters
Wind turbine inverters
Analog-to-digital and optoisolator replacement
GENERAL DES°RIPTION
The ADuM7703 is a high performance, second-order, Σ-Δ analog-
to-digital converter (ADC) with an integrated low dropout
(LDO) regulator that converts an analog input signal into a high
speed, single-bit data stream with on-chip digital isolation
based on Analog Devices, Inc., iCoupler® technology. The
achieve an 86 dB signal-to-noise ratio (SNR) at 78.1 kSPS with a
256 decimation rate and a 20 MHz master clock. The serial
input and output operates from a 5 V or a 3.3 V supply (VDD2).
The serial interface is digitally isolated. High speed complementary
metal-oxide semiconductor (CMOS) technology, combined with
monolithic transformer technology, results in the on-chip isolation
providing outstanding performance characteristics, superior to
alternatives such as optocoupler devices. The ADuM7703 device
is available in a 16-lead, wide-body SOIC with an operating
temperature range of −40°C to +125°C and an 8-lead, wide-body
SOIC with an operating temperature range of −40°C to +105°C.
device operates from a 4.5 V to 20 V power supply range (VDD1
)
and accepts a pseudo differential input signal of 250 mV
( 320 mV full-scale). The pseudo differential input is ideally
suited to shunt voltage monitoring in high voltage applications
where galvanic isolation is required.
The analog input is continuously sampled by a high performance
analog modulator and converted to a ones density digital output
stream with a data rate of up to 21 MHz. The original information
can be reconstructed with an appropriate sinc3 digital filter to
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2019 Analog Devices, Inc. All rights reserved.
www.analog.com