60 V Fault Protection and Detection,
11 Ω RON, Dual SPST Switch
ADG5421F
Data Sheet
FEATURES
FUNCTIONAL BLOCK DIAGRAM
Overvoltage fault protection up to 60 V on S1 and S2 pins
Power-off protection up to 60 V on S1 and S2 pins
Known state without digital inputs present
Low on resistance of 11 Ω typical
ADG5421F
D1
D2
S1
S2
Ultraflat, on resistance
Latch-up immune under any circumstance
3.5 kV human body model (HBM) ESD rating
FAULT
DETECTION
AND SWITCH
DRIVER
FF
VSS to VDD −2 V signal range
IN1 IN2
Fully specified at 15 V, 20 V, +12 V, and +36 V
5 V to 22 V dual-supply operation
8 V to 44 V single-supply operation
Figure 1.
10-lead, 3 mm × 2 mm, LFCSP
APPLICATIONS
Analog input and output modules
Process control and distributed control systems
Data acquisition
COMPANION PRODUCTS
Precision 24-Bit ADC: AD7768-1
Precision 16-Bit, 2 MSPS SAR ADC: AD4000
Instrumentation
Avionics
Automatic test equipment
Communication systems
Relay replacement
GENERAL DESCRIPTION
The ADG5421F is a dual SPST, low on resistance switch that
features overvoltage protection, power-off protection, and
overvoltage detection on the source pins.
PRODUCT HIGHLIGHTS
1. Source pins are protected against voltages greater than the
supply rails, up to −60 V and +60 V in both powered and
unpowered state.
When no power supplies are present, the switch remains in the
off condition, and the switch inputs are high impedance. When
powered, if the analog input signal levels on either of the Sx pins
exceed VDD or VSS by the threshold voltage, VT, both switches
turn off together, and the open-drain fault flag (FF) pin pulls to a
logic low. Input signal levels up to +60 V or −60 V relative to
ground are blocked in both the powered and unpowered
condition.
2. Overvoltage detection with digital output indicates
operating state of switches.
3. Trench isolation guards against latch-up.
4. The ADG5421F can operate from a dual supply of 5 V up
to 22 V or a single power supply of +8 V up to +44 V.
5. Negative channel metal oxide semiconductor (NMOS)
only architecture requires 2 V headroom towards VDD and
provides low RON and low RON flatness across the signal
range of VSS to VDD − 2 V.
The switches turn on with a Logic 1 input and conduct equally
well in both directions. The digital input is compatible with
1.8 V logic inputs over the full operating supply range.
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for itsuse, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice.
No license is granted by implication or otherwise under any patent or patent rights of Analog
Devices. Trademarks and registeredtrademarks are the propertyoftheir respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2020 Analog Devices, Inc. All rights reserved.
www.analog.com