User Defined Fault Protection and Detection,
0.8 pC QINJ, 8:1/Dual 4:1 Multiplexers
Data Sheet
ADG5248F/ADG5249F
FEATURES
FUNCTIONAL BLOCK DIAGRAMS
User defined secondary supplies set overvoltage level
Overvoltage protection up to −55 V and +55 V
Power-off protection up to −55 V and +55 V
Overvoltage detection on source pins
Minimum secondary supply level: 4.5 V single-supply
Interrupt flags indicate fault status
Low charge injection (QINJ): 0.8 pC
ADG5248F
S1
D
S8
Low drain/source on capacitance
ADG5248F: 19 pF
ADG5249F: 14 pF
FAULT DETECTION
AND
SWITCH DRIVER
FF
SF
Latch-up immune under any circumstance
Known state without digital inputs present
A0 A1 A2 EN POSFV NEGFV
VSS to VDD analog signal range
Figure 1. ADG5248F Functional Block Diagram
5 V to 22 V dual-supply operation
8 V to 44 V single-supply operation
Fully specified at 15 V, 20 V, +12 V, and +36 V
ADG5249F
S1A
DA
S4A
APPLICATIONS
Analog input/output modules
Process control/distributed control systems
Data acquisition
S1B
DB
S4B
Instrumentation
Avionics
FAULT DETECTION
AND
SWITCH DRIVER
FF
SF
Automatic test equipment
Communication systems
Relay replacement
A0 A1 EN POSFV NEGFV
Figure 2. ADG5249F Functional Block Diagram
The low capacitance and charge injection of these switches make
them ideal solutions for data acquisition and sample-and-hold
applications, where low glitch switching and fast settling times
are required.
GENERAL DESCRIPTION
The ADG5248F and ADG5249F are 8:1 and dual 4:1 analog
multiplexers. The ADG5248F switches one of eight inputs to a
common output, and the ADG5249F switches one of four differen-
tial inputs to a common differential output. Each channel conducts
equally well in both directions when on, and each channel has an
input signal range that extends to the supplies. The primary supply
voltages define the on-resistance profile, whereas the secondary
supply voltages define the voltage level at which the overvoltage
protection engages.
Note that, throughout this data sheet, multifunction pins, such as
A0/F0, are referred to either by the entire pin name or by a single
function of the pin, for example, A0, when only that function is
relevant.
PRODUCT HIGHLIGHTS
1. Source pins are protected against voltages greater than the
secondary supply rails, up to −55 V and +55 V.
2. Source pins are protected against voltages between −55 V
and +55 V in an unpowered state.
3. Overvoltage detection with digital output indicates
operating state of switches.
When no power supplies are present, the channel remains in the off
condition, and the switch inputs are high impedance. Under normal
operating conditions, if the analog input signal levels on any Sx pin
exceed positive fault voltage (POSFV) or negative fault voltage
(NEGFV) by a threshold voltage (VT), the channel turns off and
that Sx pin becomes high impedance. If the switch on, the drain pin
is pulled to the secondary supply voltage that was exceeded. Input
signal levels up to +55 V or −55 V relative to ground are blocked, in
both the powered and unpowered conditions.
4. Trench isolation guards against latch-up.
5. Optimized for low charge injection and on capacitance.
6. The ADG5248F/ADG5249F can be operated from a dual
supply of 5 V to 22 V or a single power supply of 8 V to 44 V.
Rev. A
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 ©2015–2016 Analog Devices, Inc. All rights reserved.
Technical Support
www.analog.com
5秒后页面跳转
解析光耦仿真器：升级光耦合器技术的必要性
英伟达新一代Blackwell GPU过热问题致交付延迟
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
