Integrated Circuit
Voltage-to-Frequency Converter
a
AD537*
FEATURES
PIN CONFIGURATIONS
Low Cost A–D Conversion
Versatile Input Amplifier
D-14 Package
H-10A Package
Positive or Negative Voltage Modes
Negative Current Mode
High Input Impedance, Low Drift
Single Supply, 5 V to 36 V
Linearity: ؎0.05% FS
Low Power: 1.2 mA Quiescent Current
Full-Scale Frequency up to 100 kHz
1.00 V Reference
Thermometer Output (1 mV/K)
F-V Applications
LOGIC GND
10
–V
IN
OUTPUT
AD537
9
1 AD537
LOGIC GND
SYNC
1
2
14
13
OUTPUT
DRIVER
+V
S
DRIVER
+V
IN
+V
2
8
7
S
I
3
4
12
11
CURR-
TO-FREQ
CONV
IN
CAP
CAP
CURR-
BUF
–V
IN
TO-FREQ
BUF
CONV
+V
IN
3
V
5
6
10
9
OS
V
V
PRECISION
VOLTAGE
T
V
CAP
TEMP
V
V
TEMP
OS
V
V
PRECISION
VOLTAGE
REFERENCE
R
REFERENCE
T
4
6
V
7
8
–V
S
REF
R
V
REF
CAP
5
MIL-STD-883 Compliant Versions Available
–V
S
(CONNECTED TO CASE)
PRODUCT DESCRIPTION
The AD537 is available in three performance/temperature
The AD537 is a monolithic V-F converter consisting of an input
amplifier, a precision oscillator system, an accurate internal ref-
erence generator and a high current output stage. Only a single
external RC network is required to set up any full-scale (F.S.)
frequency up to 100 kHz and any F.S. input voltage up to
30 V. Linearity error is as low as 0.05% for 10 kHz F.S., and
operation is guaranteed over an 80 dB dynamic range. The over-
all temperature coefficient (excluding the effects of external
components) is typically 30 ppm/°C. The AD537 operates
from a single supply of 5 V to 36 V and consumes only 1.2 mA
quiescent current.
grades; the J and K grades are specified for operation over the
0°C to +70°C range while the AD537S is specified for operation
over the extended temperature range, –55°C to +125°C.
PRODUCT HIGHLIGHTS
1. The AD537 is a complete V-F converter requiring only an
external RC timing network to set the desired full-scale fre-
quency and a selectable pull-up resistor for the open collec-
tor output stage. Any full-scale input voltage range from
100 mV to 10 volts (or greater, depending on +VS) can be
accommodated by proper selection of timing resistor. The
full-scale frequency is then set by the timing capacitor from
the simple relationship, f = V/10RC.
A temperature-proportional output, scaled to 1.00 mV/K,
enables the circuit to be used as a reliable temperature-to-
frequency converter; in combination with the fixed reference
output of 1.00 V, offset scales such as 0°C or 0°F can be generated.
2. The power supply requirements are minimal, only 1.2 mA
quiescent current is drawn from a single positive supply from
4.5 volts to 36 volts. In this mode, positive inputs can vary
from 0 volts (ground) to (+VS – 4) volts. Negative inputs can
easily be connected for below ground operation.
The low drift (1 µV/°C typ) input amplifier allows operation
directly from small signals (e.g., thermocouples or strain gages)
while offering a high (250 MΩ) input resistance. Unlike most
V–F converters, the AD537 provides a square-wave output, and
can drive up to 12 TTL loads, LEDs, very long cables, etc.
3. F-V converters with excellent characteristic are also easy to
build by connecting the AD537 in a phase-locked loop. Ap-
plication particulars are shown in Figure 6.
The excellent temperature characteristics and long-term stability
of the AD537 are guaranteed by the primary bandgap reference
generator and the low T.C. silicon chromium thin film resistors
used throughout.
4. The versatile open-collector NPN output stage can sink up
to 20 mA with a saturation voltage less than 0.4 volts. The
Logic Common terminal can be connected to any level be-
tween ground (or –VS) and 4 volts below +VS. This allows
easy direct interface to any logic family with either positive or
negative logic levels.
The device is available in either a 14-lead ceramic DIP or a 10-lead
metal can; both are hermetically sealed packages.
5. The AD537 is available in versions compliant with MIL-
STD-883. Refer to the Analog Devices Military Product
Databook or current AD537/883B data sheet for detailed
specifications.
*Protected by Patent Nos. 3,887,963 and RE 30,586.
REV. C
Information furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assumed by Analog Devices for its
use, nor for any infringements of patents or other rights of third parties
which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781/329-4700
Fax: 781/326-8703
World Wide Web Site: http://www.analog.com
© Analog Devices, Inc., 2000
5秒后页面跳转
解析光耦仿真器：升级光耦合器技术的必要性
英伟达新一代Blackwell GPU过热问题致交付延迟
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
替代型号
如果您发现信息不准确，
