9ZXL0831E / 9ZXL0851E Datasheet
Electrical Characteristics–Current Consumption
TAMB = over the specified operating range. Supply voltages per normal operation conditions; see Test Loads for loading conditions
Symbol
Parameter
Conditions
Minimum
Typical Maximum Units
Notes
IDDA
Operating Supply Current
VDDA, PLL Mode at 100MHz
37
55
3
45
68
4
mA
mA
mA
mA
1
IDD
Operating Supply Current
Powerdown Current
Powerdown Current
All other VDD pins at 100MHz
VDDA, CKPWRGD_PD# = 0
IDDAPD
IDDPD
1
All other VDD pins, CKPWRGD_PD# = 0
1
2
1. Includes VDDR if applicable.
Electrical Characteristics–HCSL/LP-HCSL Outputs
TAMB = over the specified operating range. Supply voltages per normal operation conditions; see Test Loads for loading conditions
Specification
Limit
Symbol
Parameter
Conditions
Minimum Typical Maximum
Units Notes
dV/dt
ΔdV/dt
Vmax
Vmin
Vcross_abs
Δ-Vcross
Slew Rate
Slew Rate Matching
Max Voltage
Min Voltage
Crossing Voltage (abs)
Crossing Voltage (var)
Scope averaging on.
Single-ended measurement.
Measurement on single-ended signal using
absolute value (scope averaging off).
Scope averaging off.
2
2.9
7.1
792
-35
372
15
4
20
850
150
550
140
1
4
V/ns
%
1, 2, 3
1, 4, 7
7
–
20
660
-150
250
1150
-300
250 – 550
140
mV
7
mV
mV
1, 5, 7
1, 6, 7
Scope averaging off.
1Guaranteed by design and characterization, not 100% tested in production.
2 Measured from differential waveform.
3 Slew rate is measured through the Vswing voltage range centered around differential 0V. This results in a +/-150mV window around differential 0V.
4 Matching applies to rising edge rate for Clock and falling edge rate for Clock#. It is measured using a +/-75mV window centered on the average cross point
where Clock rising meets Clock# falling. The median cross point is used to calculate the voltage thresholds the oscilloscope is to use for the edge rate calculations.
5 Vcross is defined as voltage where Clock = Clock# measured on a component test board and only applies to the differential rising edge (i.e. Clock rising and
Clock# falling).
6 The total variation of all Vcross measurements in any particular system. Note that this is a subset of Vcross_min/max (Vcross absolute) allowed. The intent is to
limit Vcross induced modulation by setting Δ-Vcross to be smaller than Vcross absolute.
7 At default SMBus settings.
©2018 Integrated Device Technology, Inc
7
August 14, 2018