www.make-ps.com
E-mail:info@make-ps.com
3000WFR series
Single, Dual, Triple Output
DC/DC Converter
FEATURES
• 6 sided Continuous Shielding
• Remote On/Off Control
• Wide 2:1 Input Voltage Range
• Efficiency to 85%
• Output Voltage Trim up to 10%
INPUT CHARACTERISTICS
DESCRIPTIONS
Unit/Comments
Min Typ Max
The 3000WFR series is a family of compact 25W to 30W, high
performance DC/DC converters. These converters are
specifically designed to provide the flexibility, power density,
and reliability required to fulfill local power needs in
applications ranging from telecom switch systems to
portable instrumentation. 27 models operate over 2:1 input
ranges of 9 to 18, 18 to 36 or 36 to 72 VDC; providing single,
dual or triple output combinations of 3.3, 5, 12, 15, 5, 12,
15, 5 12 and 5 15 VDC. All models are packaged in
compact, low profile 2.0” X 2.0” X 0.4” metal cases.
Input Voltage Range
12 VDC Input Models
24 VDC Input Models
48 VDC Input Models
Remote ON / OFF Control
Supply ON
VDC
VDC
VDC
9
12 18
18 24 36
36 48 72
5.5 VDC or Open Circuit
0 VDCto 0.8VDC
Supply OFF
Logic Referenced to Negative Input
Input Filter
Pi Filter
OUTPUT CHARACTERISTICS
GENERAL CHARACTERISTICS
Min Typ Max Unit/Comments
Min Typ Max Unit/Comments
Output Voltage Accuracy
Switching Frequency
Isolation Voltage
Isolation Resistance
300
kHz
1
Single & Dual Outputs
Triple Outputs- Primary
2
2
5
%
%
%
500
VDC, 1 minute
Mohm, 500VDC
1
1
1
1000
- Auxiliaries
Output Voltage Trim
Voltage Balance:
Dual Outputs
10 %
2
%; Equal Output Loads
Triple Outputs (Auxiliaries)
Minimum Load
Line Regulation
Single Outputs
Dual Outputs
Triple Outputs- Primary
- Auxiliaries
100 mV; Equal Output Loads
10% Full Load
2
0.5 %
2
0.5 %
2
1
5
%
%
2
Load Regulation
Single Outputs
Dual Outputs
Triple Outputs- Primary
- Auxiliaries
Ripple/Noise
5V Outputs
3
3
1
1
1
5
%
% ; Equal Loads
3
%
3
% ; Equal Loads
75 mV; p-p, Nom.Line FL,
20Mhz B.W. using
1 μf bypass capacitor
% of Vout
Continuous, Auto-
matic Recovery
12V and 15V Outputs
Short Circuit Protection
1
1
= Output voltage at nominal line & FL
= % Output voltage measured from min. input line to maximum
= Output voltage measured from FL to 10% Load
2
3
Transient Recovery Time
100 μS to within1% error
band for 50% step
load change
0.01 % per C
See Model Selection Guide
o
Temperature Coefficient
Over Voltage Protection
>> 1