Z86E73/E74/L73/L74
CP95LVO0801
P R E L I M I N A R Y
PRELIMINARY
CUSTOMER PROCUREMENT SPECIFICATION
Z86E73/E74 32K OTP
Z86L73/L74 32K ROM
INFRARED REMOTE CONTROLLERS
FEATURES
■
■
Expanded Register Files (ERF)
ROM
RAM*
One-Time
Speed
Part
(Kbyte) (Kbyte) Programmable (MHz)
31 Input/Output Lines (E73/L73)
51 Input/Output Lines (E74/L74*)
Z86E73
Z86L73
Z86E74
Z86L74
32
32
32
32
1004
492
1004
1004
Yes
No
Yes
No
8
8
8
8
*Note: With Auto Latch on Port 4, 5 and 6.
Five Prioritized Interrupts with Programmable Polarity
Two Comparators
* General-Purpose
■
■
■
■
■
■
40-Pin DIP, 44-Pin PLCC/QFP Packages (E73/L73)
64-Pin DIP, 68-Pin PLCC Packages (E74/L74)
8-Bit Counter/Timer with Two Capture Registers and
16-Bit Counter/Timer with One Capture Register
2.0V to 3.9V Operating Range (L73/L74)
4.5V to 5.5V Operating Range (E73/E74)
■
■
Watch-Dog Timer (WDT)/Power-On Reset (POR)
Low-Power Consumption
(Typical: 40 mw for L73/L74)
(Typical: 60 mw for E73/E74)
On-Chip Oscillator that Accepts a Crystal, Ceramic
Resonator, LC, RC, or External Clock Drive
■
0°C to +70°C Temperature Range
■
■
Low-Voltage Detection and Protection
32-KHz Mask Option to Disable Internal Feedback
Resistor (L73/L74)
GENERAL DESCRIPTION
The Z86E73/L73/E74/L74 are ROM-based members of
Zilog's Z8® single-chip microcontroller family of infrared
(IR) consumer controller processors featuring fast and
flexible code execution. The Z86E73/E74 devices offer a
one-time programmable (OTP) option.
Two on-chip counter/timers, with a large number of
selectable modes, offload the system of administering
re a l-time ta s ks s uc h a s c ounting /timing a nd I/O
datacommunications.
Notes:
All Signals with a preceding front slash, "/", are active Low, e.g.,
B//W (WORD is active Low); /B/W (BYTE is active Low, only).
For applications demanding powerful I/O capabilities, the
Z86E73/L73's dedicated inputand outputlines are grouped
into four ports, and into seven ports for the Z86E74/L74.
They are configurable under software control to provide
timing, status signals, or parallel I/O.
Power connections follow conventional descriptions below:
Connection
Circuit
Device
Power
Ground
VCC
GND
VDD
Four address spaces, the Program Memory, Register File,
Data Memory, and Expanded Register File (ERF) support
a wide range of memory configurations. Through the ERF
the designerhas access to three additionalcontrolregisters
thatprovide extra peripheraldevices, I/O ports, and register
addresses.
V
SS
CP95LVO0801
1