X9C303
®
Terminal Voltage ±5V, 100 Taps, Log Taper
Data Sheet
March 11, 2005
FN8223.0
DESCRIPTION
Digitally Controlled Potentiometer
(XDCP™)
The Intersil X9C303 is a digitally controlled potentiom-
eter (XDCP). The device consists of a resistor array,
wiper switches, a control section, and nonvolatile
memory. The wiper position is controlled by a three-
wire interface.
FEATURES
• Solid-state potentiometer
• Three-wire serial interface
• 100 wiper tap points
—Wiper position stored in nonvolatile memory
and recalled on power-up
• 99 resistive elements, log taper
—Temperature compensated
—End to end resistance, ±15%
—Terminal voltages, ±5V
The resistor array is composed of 99 resistive ele-
ments. Between each element and at either end are
tap points accessible to the wiper terminal. The posi-
tion of the wiper element is controlled by the CS, U/D,
and INC inputs. The position of the wiper can be
stored in nonvolatile memory and then be recalled
upon a subsequent power-up operation.
• Low power CMOS
—V = 5V
The device can be used as a three-terminal potentio-
meter or as a two-terminal variable resistor in a wide
variety of applications ranging from control, to signal
processing, to parameter adjustment. Digitally-
controlled potentiometers provide three powerful appli-
cation advantages; (1) the variability and reliability of a
solid-state potentiometer, (2) the flexibility of com-
puter-based digital controls, and (3) the use of nonvol-
atile memory for potentiometer settings retention.
CC
—Active current, 3mA max.
—Standby current, 750µA max.
• High reliability
—Endurance, 100,000 data changes per bit
—Register data retention, 100 years
• X9C303, 32kΩ
• Packages
—8-lead TSSOP
—8-lead SOIC
—8-pin DIP
BLOCK DIAGRAM
U/D
INC
CS
7-Bit
Up/Down
Counter
99
98
97
96
RH/VH
7-Bit
Nonvolatile
Memory
One
of
One-
Resistor
Transfer
Gates
Hundred
Decoder
Array
2
1
0
Store and
Recall
Control
Circuitry
VCC
VSS
RL/VL
RW/VW
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
XDCP is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
1