Approval sheet
TEST AND REQUIREMENTS
TEST
PROCEDURE
REQUIREMENT
High temperature exposure
MIL-STD-202-108
Temperature cycling
JESD22 JA-104
no visible damage
R/R max. ±3%
no visible damage
R/R max. ±1%
Ambient temperature 1552C, no load, 1000 hrs
1. 30 minutes at -55C3C,
2. 2~3 minutes at room temperature,
3. 30 minutes at +1253C,
4. 2~3 minutes at room temperature,
Total 1000 continuous cycles
Bias Humidity
no visible damage
Condition85C & 85% R.H.
Test power10% of rated power shall be applied
continuously. Duration 1000hrs
R/R max. ±3%
MIL-STD-202-103
Ambient temperature: 125±2ºC
The applied voltage shall be the voltage to be
calculated at 35% of rated dissipation or the
no visible damage
Operational Life
MIL-STD-202-108
R/R max. ±3%
limiting element voltage whichever is the smaller.
Condition: The voltage shall be applied continuously.
Duration: 1000 hrs
JESD22 Method JB-100
Meet dimension spec as
defined in p.3
Dimension
Resistance to Solvents
MIL-STD-202-215
R/R: max 1%
No visible damage
Solvent: 2−propanol at 25℃
Immersion time: 3 min
Brush: 10 times brushing
Immersion and brush cycle: 3cycle
Mechanical Shock
MIL-STD-202-213
Waveform: half sine,
Peak value100G,
Normal duration 6ms
R/R: max. 1%
No visible damage
Condition: XX'YY'ZZ', 10times each
Peak acceleration and Sweep time: 5 g's for 20
min , Frequency 10Hz to 2000Hz,
Condition: 12 cycles each of 3 orientations
Vibration
MIL-STD-202-204
R/R: max 1%
No visible damage
R/R: max 1%
No visible damage
Resistance to soldering heat
MIL-STD-202-210
Un-mounted chips 10±0.5 seconds, 260±5ºC
ESD test
AEC Q200-002
Human body model, 2 Kohm, 150 pF,
Test voltage: 8KV
R/R: max %
No visible damage
Solderability
J-STD-002
good tinning (>95%
covered)
a)4hrs / 155℃*dry then solder dipping 235℃/5sec
b)Steam 8 hrs then 215℃ / 5sec solder dipping
c)Steam 8 hrs then 260℃ / 7sec solder dipping
Bending 2mm for 60 seconds.
no visible damage
R/R: max 1%
No visible damage
Bending strength
AEC Q200-005
Adhesion
R/R: max 1%
Pressurizing force: 17.7N, Test time: 60±1s.
No visible damage
AEC Q200-006
R/R: max 2% No
visible damage
Sulfuration test
ASTM B-809-95 105’C 1000hrs
ASTM B-809-95
Page 7 of 7
ASC_WW25R_J_AUTO_V02
Nov - 2023