MODEL: WRPP
Dual Output Plug-in Signal Conditioners W-UNIT
[3] OUTPUT 2
A: Open collector (max. frequency 100 kHz)
K: 3.3 V pulse (max. frequency 1 MHz)
ENCODER SIGNAL DISTRIBUTOR
(rotary encoder use)
M: 5 V pulse (max. frequency 500 kHz)
N: 12 V pulse (max. frequency 100 kHz)
J: RS-422 line driver pulse (max. frequency 1 MHz)
Functions & Features
• Isolating two phase pulse input signals from a rotary
encoder and distributing them to two outputs (input
frequency = output frequency)
[4] OUTPUT LOGIC (both Input 1 & 2)
N: The same as the input
• Various outputs (open collector, voltage pulse, RS-422 line
driver pulse)
R: Inverted
• Can be used as a pulse isolator of two different I/O specs
• Converting RS-422 line driver pulse into an open collector
pulse
[5] POWER INPUT
AC Power
• Isolation up to 2000 V AC
M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,
• Maximum frequency of 1 MHz
47 – 66 Hz)
DC Power
72
(2.83)
R: 24 V DC
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
R2: 11 – 27 V DC
80
(3.15)
(Operational voltage range 11 – 27 V, ripple 10 %p-p max.)
(CE not available)
P: 110 V DC
(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)
136
(5.35)
mm (inch)
[6] OPTIONS
blank: none
MODEL: WRPP–[1][2][3][4]-[5][6]
/Q: With options (specify the specification)
ORDERING INFORMATION
• Code number: WRPP-[1][2][3][4]-[5][6]
Specify a code from below for each of [1] through [6].
(e.g. WRPP-JJJN-R/Q)
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
/C02: Polyurethane coating
• Specify the specification for option code /Q
(e.g. /C01/S01)
/C03: Rubber coating
TERMINAL SCREW MATERIAL
/S01: Stainless steel
[1] INPUT
A1: Dry contact
GENERAL SPECIFICATIONS
Construction: Plug-in
K: 3.3 V pulse
C: 5 V pulse
Connection: M3.5 screw terminals
D: 12 V/24 V pulse
J: RS-422 line driver pulse
Screw terminal: Chromated steel (standard) or stainless
steel
Housing material: Flame-resistant resin (black)
Isolation: Input to output 1 to output 2 to power
Input monitor LED: Available to check input pulse existence
Input pulse sensing: DC coupled
[2] OUTPUT 1
A: Open collector (max. frequency 100 kHz)
K: 3.3 V pulse (max. frequency 1 MHz)
M: 5 V pulse (max. frequency 500 kHz)
N: 12 V pulse (max. frequency 100 kHz)
J: RS-422 line driver pulse (max. frequency 1 MHz)
WRPP SPECIFICATIONS
ES-2222 Rev.3 Page 1/4
http://www.m-system.co.jp/