WM9713L
1
AC’97 Audio + Touchpanel CODEC
DESCRIPTION
FEATURES
• AC’97 Rev 2.2 compatible stereo codec
- DAC SNR 94dB, THD –85dB
The WM9713L is a highly integrated input/output device
designed for mobile computing and communications.
- ADC SNR 87dB, THD –86dB
The chip is architected for dual CODEC operation,
supporting Hi-Fi stereo Codec functions via the AC link
interface, and additionally supporting voice Codec functions
via a PCM type Synchronous Serial Port (SSP). A third Aux
DAC is provided which may be used to support generation
of supervisory tones, or ring-tones etc. at different sample
rates to the main codec.
- Variable Rate Audio, supports all WinCE sample rates
- Tone Control, Bass Boost and 3D Enhancement
• On-chip 45mW headphone driver
• On-chip 400mW mono or stereo speaker drivers
• Stereo, mono or differential microphone input
- Automatic Level Control (ALC)
- Mic insert and mic button press detection
• Auxiliary mono DAC (ring tone or DC level generation)
• Seamless interface to wireless chipset
• Resistive touchpanel interface
The device can connect directly to a 4-wire or 5-wire touch-
panel, mono or stereo microphones, stereo headphones
and a stereo speaker, reducing total component count in the
system. Cap-less connections to the headphones,
speakers, and earpiece may be used, saving cost and
board area. Additionally, multiple analog input and output
pins are provided for seamless integration with analog
connected wireless communication devices.
- Supports 4-wire and 5-wire panels
- 12-bit resolution, INL 2 LSBs (<0.5 pixels)
- X, Y and touch-pressure (Z) measurement
- Pen-down detection supported in Sleep Mode
• Additional PCM/I2S interface to support voice CODEC
• PLL derived audio clocks.
All device functions are accessed and controlled through a
single AC-Link interface compliant with the AC’97 standard.
The 24.576 MHz masterclock can be input directly or
generated internally from a 13MHz (or other frequency)
clock by an onboard PLL. The PLL supports a wide range
of input clock from 2.048Mhz to 78.6Mhz.
• Supports input clock ranging from 2.048Mhz to 78.6Mhz
• 1.8V to 3.6V supplies (digital down to 1.62V, speaker up to
4.2V)
• 7x7mm 48-pin QFN package
APPLICATIONS
The WM9713L operates at supply voltages from 1.8 to 3.6
Volts. Each section of the chip can be powered down under
software control to save power. The device is available in a
small leadless 7x7mm QFN package, ideal for use in hand-
held portable systems.
• Personal Digital Assistants (PDA) with or without phone
• Smartphones
• Handheld and Tablet Computers
BLOCK DIAGRAM
WOLFSON MICROELECTRONICS plc
Preliminary Technical Data, March 2004, Rev 2.2
www.wolfsonmicro.com
Copyright 2004 Wolfson Microelectronics plc