5秒后页面跳转
WM71008-NBSD-DATR PDF预览

WM71008-NBSD-DATR

更新时间: 2024-02-02 10:30:44
品牌 Logo 应用领域
铁电 - RAMTRON 光电二极管内存集成电路
页数 文件大小 规格书
17页 1898K
描述
Memory Circuit, PDSO8, 3 X 3 MM, 0.65 MM PITCH, GREEN, UDFN-8

WM71008-NBSD-DATR 技术参数

生命周期:Obsolete零件包装代码:DFN
包装说明:,针数:8
Reach Compliance Code:unknownHTS代码:8542.32.00.71
风险等级:5.84JESD-30 代码:S-PDSO-N8
内存集成电路类型:MEMORY CIRCUIT端子数量:8
封装主体材料:PLASTIC/EPOXY封装形状:SQUARE
封装形式:SMALL OUTLINE认证状态:Not Qualified
表面贴装:YES端子形式:NO LEAD
端子位置:DUALBase Number Matches:1

WM71008-NBSD-DATR 数据手册

 浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第1页浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第2页浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第4页浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第5页浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第6页浏览型号WM71008-NBSD-DATR的Datasheet PDF文件第7页 
WM710xx – Secure F-RAM with Gen-2 RFID  
FUNCTIONAL DESCRIPTION  
The WM710xx is a non-volatile memory device with an industry standard UHF RFID interface that enables  
processing data in and out of memory as a generic passive RFID transponder. Unlike other transponder ICs,  
the WM710xx transponder IC contains high density symmetric read/write F-RAM memory that enables unique  
applications of an RFID solution.  
When combined with an appropriate antenna design, WM710xx will power up with energy harvested directly  
from the RF field. Following an internally generated reset state, the IC configures itself according to pre-  
programmed configuration settings that were stored in F-RAM non-volatile memory at wafer probe, packaged  
parts test, or end unit transponder personalization at end-user depot. Configuration settings are read out of  
memory and applied prior to enabling data transmission in or out of memory.  
As specified in the Gen2 standard, the chip receives and processes commands transmitted by the RFID  
interrogator (reader). All required and most optional commands are supported. In addition to these,  
WM710xx supports a number of custom commands that take advantage of F-RAM’s unique ultra low power  
and symmetrical characteristics.  
Referring to Figure 2, the transponder IC’s consist of an RFID interface, control and authentication logic, F-  
RAM memory, and power management unit. The external antenna is connected directly to the RFID interface  
where the RF signal is rectified with high efficiency Schottky diode based rectifier. The rectified voltage is  
multiplied up within the Schottky array and then regulated to supply power to on-chip resources.  
Also included in the RFID Interface is a modulator/demodulator that detects incoming signals and modulates  
the input impedance to enable backscattering of returned signals. The control and authentication logic  
processes commands to enable access in and out of F-RAM memory.  
Control and  
RFID  
Authentication  
Logic  
Interface  
Power  
External  
MCU  
F-RAM Array  
Management  
(16Kb)  
(Optional)  
Figure 2. Block Diagram  
Rev. 1.2  
Sept. 2010  
Page 3 of 17  

与WM71008-NBSD-DATR相关器件

型号 品牌 描述 获取价格 数据表
WM71016-6-DGTR RAMTRON Memory Circuit

获取价格

WM71016-NBSD-DA RAMTRON Memory Circuit, PDSO8, 3 X 3 MM, 0.65 MM PITCH, GREEN, UDFN-8

获取价格

WM71016-NBSD-DATR RAMTRON Memory Circuit, PDSO8, 3 X 3 MM, 0.65 MM PITCH, GREEN, UDFN-8

获取价格

WM7120A WOLFSON Top Port Analogue Silicon Microphone

获取价格

WM7120AE WOLFSON Top Port Analogue Silicon Microphone

获取价格

WM7120AIMS/RV CIRRUS Analog Circuit, 1 Func, CMOS, PBGA4, 3.76 X 2.95 MM, 1.10 MM HEIGHT, HALOGEN AND LEAD FREE

获取价格